Section 17 I2C Bus Interface 2 (IIC2)
Initial
Bit
5
Bit Name Value
R/W
R/W
R/W
Description
MST
TRS
0
0
Master/Slave Select
Transmit/Receive Select
4
In master mode with the I2C bus format, when arbitration
is lost, MST and TRS are both reset by hardware,
causing a transition to slave receive mode. Modification
of the TRS bit should be made between transfer frames.
After data receive has been started in slave receive
mode, when the first seven bits of the receive data agree
with the slave address that is set to SAR and the eighth
bit is 1, TRS is automatically set to 1. If an overrun error
occurs in master mode with the clock synchronous serial
format, MST is cleared to 0 and slave receive mode is
entered.
Operating modes are described below according to MST
and TRS combination. When clock synchronous serial
format is selected and MST is 1, clock is output.
00: Slave receive mode
01: Slave transmit mode
10: Master receive mode
11: Master transmit mode
Transfer Clock Select 3 to 0
3
2
1
0
CKS3
CKS2
CKS1
CKS0
0
0
0
0
R/W
R/W
R/W
R/W
These bits should be set according to the necessary
transfer rate (see table 17.2) in master mode. In slave
mode, these bits are used for reservation of the setup
time in transmit mode. The time is 10 tcyc when CKS3 = 0
and 20 tcyc when CKS3 = 1.
Rev. 3.00 Sep. 10, 2007 Page 333 of 528
REJ09B0216-0300
RENESAS [ RENESAS TECHNOLOGY CORP ]
