Bit 6—Serial Port RTS Port Data (RTSDT): Specifies the serial port 5765 pin input/output
data. Input or output is specified by the RTSIO pin (see the description of bit 7, RTSIO, for
details). When the 5765 pin is designated as an output, the value of the RTSDT bit is output to the
5765 pin. The 5765 pin value is read from the RTSDT bit regardless of the value of the RTSIO
bit. The initial value of this bit after a power-on reset or manual reset is undefined.
Bit 6: RTSDT
Description
0
1
Input/output data is low-level
Input/output data is high-level
Bit 5—Serial Port CTS Port I/O (CTSIO): Specifies serial port &765 pin input/output. When
the &765 pin is actually set as a port output pin and outputs the value set by the CTSDT bit, the
MCE bit in SCFCR2 should be cleared to 0.
Bit 5: CTSIO
Description
0
1
CTSDT bit value is not output to the &765 pin
CTSDT bit value is output to the &765 pin
(Initial value)
Bit 4—Serial Port CTS Port Data (CTSDT): Specifies the serial port &765 pin input/output
data. Input or output is specified by the CTSIO pin (see the description of bit 5, CTSIO, for
details). When the &765 pin is designated as an output, the value of the CTSDT bit is output to the
&765 pin. The &765 pin value is read from the CTSDT bit regardless of the value of the CTSIO
bit. The initial value of this bit after a power-on reset or manual reset is undefined.
Bit 4: CTSDT
Description
0
1
Input/output data is low-level
Input/output data is high-level
Bits 3 and 2—Reserved: These bits are always read as 0, and should only be written with 0.
Bit 1—Serial Port Break I/O (SPB2IO): Specifies the serial port TxD2 pin output condition.
When the TxD2 pin is actually set as a port output pin and outputs the value set by the SPB2DT
bit, the TE bit in SCSCR2 should be cleared to 0.
Bit 1: SPB2IO
Description
0
1
SPB2DT bit value is not output to the TxD2 pin
SPB2DT bit value is output to the TxD2 pin
(Initial value)
Rev. 6.0, 07/02, page 749 of 986
RENESAS [ RENESAS TECHNOLOGY CORP ]
