TS1
T1
TB2 TH1 TS1 TB1 TB2 TH1 TS1 TB1 TB2 TH1 TS1 TB1
T2
TH1
CKIO
A25–A5
A4–A0
RD/
D63–D0
(read)
DACKn
(SA: IO ← memory)
Note: For DACKn, an example is shown where CHCRn.AL (access level) = 0 for the DMAC.
Figure 13.48 Burst ROM Wait Access Timing
13.3.7 PCMCIA Interface
In the SH7750 Series, setting the A56PCM bit in BCR1 to 1 makes the bus interface for external
memory space areas 5 and 6 an IC memory card interface or I/O card interface as stipulated in
JEIDA specification version 4.2 (PCMCIA2.1).
Figure 13.49 shows an example of PCMCIA card connection to the SH7750 Series. To enable
active insertion of the PCMCIA cards (i.e. insertion or removal while system power is being
supplied), a 3-state buffer must be connected between the SH7750 Series’ bus interface and the
PCMCIA cards.
As operation in big-endian mode is not explicitly stipulated in the JEIDA/PCMCIA specifications,
the SH7750 Series supports only a little-endian mode PCMCIA interface.
In the SH7750, the PCMCIA interface area can only be accessed when the MMU is used. The
PCMCIA interface memory space can be set in page units and there is a choice of 8-bit common
memory, 16-bit common memory, 8-bit attribute memory, 16-bit attribute memory, 8-bit I/O
space, 16-bit I/O space, or dynamic bus sizing, according to the accessed SA2 to SA0 bits.
The setting for wait cycles during a bus access can also be made in MMU page units. When the
TC bit to be accessed is cleared to 0, bits A5W2 to A5W0 in wait control register 2 (WCR2), and
bits A5PCW1 and A5PCW0, A5TED2 to A5TED0, and A5TEH2 to A5TEH0 in the PCMCIA
Rev. 6.0, 07/02, page 444 of 986
RENESAS [ RENESAS TECHNOLOGY CORP ]
