Data Sheet
HY[B/E]18M1G16[0/1]BF
1-Gbit DDR Mobile-RAM
Data from any READ burst may be concatenated with or truncated with data from a subsequent READ command. In either
case, a continuous flow of data can be maintained. The first data element from the new burst follows either the last element of
a completed burst or the last desired data element of a longer burst which is being truncated.
The new READ command should be issued x cycles after the first READ command, where x equals the number of desired data
element pairs (pairs are required by the 2n pre fetch architecture). This is shown in Figure 15.
FIGURE 15
Consecutive READ Bursts
CK
CK
Command
READ
NOP
READ
NOP
NOP
NOP
Address
BA,Col n
BA,Col b
CL=2
DQS
DQ
DO n
DO b
CL=3
DQS
DQ
DO n
DO b
= Don't Care
DO n (or b) = Data Out from column n (or column b)
Burst Length = 4, 8 or 16 (if 4, the bursts are concatenated; if 8 or 16, the second burst interrupts the first)
3 subsequent elements of Data Out appear in the programmed order following DO n
3 (or 7 or 15) subsequent elements of Data Out appear in the programmed order following DO b
Read commands shown must be to the same device
Rev.1.0, 2007-03
10242006-Y557-TZXW
25
QIMONDA [ QIMONDA AG ]
