Notice
12. Component Mounting
If low bottom dead point of the pick-up nozzle is too low, chip cracks will be occurred because an extra power will be
added to the chip during mounting. Therefore, the bottom dead point of pick-up nozzle must be set on/over the upper
surface of the PCB. Adjusting is required when the bottom dead point will be set by correcting board warp.
It is recommended that using the larger pick-up nozzle than chip length for avoiding what force impact will be centered
to the middle point of components. Before assembling, please confirm its mounting accuracy under the best condition.
pick-up nozzle
吸着ノズル
吸着ノズル投影線
shape of pick-up nozzle
good
○
poor
×
チップ搭載時の
pick-up nozzle position
吸着ノズル位置
longer direction of
吸着ノズル長手寸法
吸着ノズルの設定下死点
position adjusting of
in component placing
pick-up nozzle
bottom dead point
13. Standard Land Dimensions
The chip EMI filter suppresses noise by conducting the high-frequency noise element to ground.
Therefore, to get enough noise reduction, feed through holes which is connected to ground-plane should be
arranged according to the figure to reinforce the ground-pattern.
In case of changing the land dimentions marked by ※, a solder bridge between terminations of the chip
could occur. In this case, please contact us before change.
< Standard land dimensions for reflow >
･Side on which chips are mounted
(in mm)
14. Storage condition
(1) Storage period
Use the products within 12 months after delivered.
Solderability should be checked if this period is exceeded.
(2) Storage environment condition
・Products should be stored in the warehouse on the following conditions.
Temperature: -10 to +40°C
Humidity: 15 to 85% relative humidity
No rapid change on temperature and humidity
・Don't keep products in corrosive gases such as sulfur, chlorine gas or acid, or it may cause oxidization of electrode,
resulting in poor solderability.
・Products should be stored on the palette for the prevention of the influence from humidity, dust and so on.
・Products should be stored in the warehouse without heat shock, vibration, direct sunlight and so on.
・Products should be stored under the airtight packaged condition.
(3) Delivery
Care should be taken when transporting or handling product to avoid excessive vibration or mechanical shock.
JEMCPC-02243B
9
MURATA [ muRata ]
