‡
Pre lim in a ry
MT9V012 - 1/6-In ch VGA CMOS Dig it a l Im a g e Se n so r
Op e ra t in g Mo d e s
Se ria l Mo d e
This section shows a typical configuration schematic, including the ball diagram and
ball description, for the MT9V012 operating in serial mode. This mode operates only at
2.5V to 3.1V VDD range.
Fig u re 3: Typ ica l Co n fig u ra t io n : Se ria l Mo d e
Analog
Power
Digital
Power
1
1
VDD
VAA
VAAPIX
4
D
OUT (9:0)
MODE0
MODE1
CLKIN
4
4
LINE_VALID
MASTER CLOCK
(162 MHz)
FRAME_VALID
STANDBY
From
Controller
Digital
Ground
S
DATA
SCLK
D
OUT
P
TEST
To
DOUT
N
Controller
RESET#
FLASH
10µF
DGND
AGND
Digital
Ground
Analog
Ground
Notes: 1. All power supplies should be adequately decoupled.
2. Resistor value 1.5KΩ is recommended, but may be greater for slower two-wire speed.
3. This pull-up resistor is not required if the controller drives a valid logic level on SCLK at all
times.
4. Connect to digital ground directly or through a 10K resistor. Some of these signals have
on-die pull-down resistors in this mode and could be left unconnected.
PDF: 814eb99f/Source: 8175e929
MT9V012_2.fm - Rev. B 2/05 EN
Micron Technology, Inc., reserves the right to change products or specifications without notice.
8
©2004 Micron Technology, Inc. All rights reserved.
MICRON [ MICRON TECHNOLOGY ]
