PIC24FJ64GA104 FAMILY
REGISTER 22-1: CMxCON: COMPARATOR x CONTROL REGISTERS
(COMPARATORS 1 THROUGH 3)
R/W-0
CEN
R/W-0
COE
R/W-0
CPOL
U-0
—
U-0
—
U-0
—
R/W-0
CEVT
R-0
COUT
bit 15
bit 8
R/W-0
R/W-0
U-0
—
R/W-0
CREF
U-0
—
U-0
—
R/W-0
CCH1
R/W-0
CCH0
EVPOL1
EVPOL0
bit 7
bit 0
Legend:
R = Readable bit
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared x = Bit is unknown
-n = Value at POR
bit 15
bit 14
bit 13
CEN: Comparator Enable bit
1= Comparator is enabled
0= Comparator is disabled
COE: Comparator Output Enable bit
1= Comparator output is present on the CxOUT pin.
0= Comparator output is internal only
CPOL: Comparator Output Polarity Select bit
1= Comparator output is inverted
0= Comparator output is not inverted
bit 12-10
bit 9
Unimplemented: Read as ‘0’
CEVT: Comparator Event bit
1= Comparator event defined by EVPOL<1:0> has occurred; subsequent triggers and interrupts are
disabled until the bit is cleared
0= Comparator event has not occurred
bit 8
COUT: Comparator Output bit
When CPOL = 0:
1= VIN+ > VIN-
0= VIN+ < VIN-
When CPOL = 1:
1= VIN+ < VIN-
0= VIN+ > VIN-
bit 7-6
EVPOL<1:0>: Trigger/Event/Interrupt Polarity Select bits
11= Trigger/event/interrupt generated on any change of the comparator output (while CEVT = 0)
10= Trigger/event/interrupt generated on transition of the comparator output:
If CPOL = 0 (non-inverted polarity):
High-to-low transition only.
If CPOL = 1 (inverted polarity):
Low-to-high transition only.
01= Trigger/event/interrupt generated on transition of comparator output:
If CPOL = 0 (non-inverted polarity):
Low-to-high transition only.
If CPOL = 1 (inverted polarity):
High-to-low transition only.
00= Trigger/event/interrupt generation is disabled
bit 5
Unimplemented: Read as ‘0’
2010 Microchip Technology Inc.
DS39951C-page 231
MICROCHIP [ MICROCHIP ]
