Smallest TEC Power Drivers for
Optical Modules
Package Information
(The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information,
go to www.maxim-ic.com/packages.)
D2
0.15
C A
D
b
0.10 M
C A B
C
L
D2/2
D/2
k
PIN # 1
I.D.
0.15
C
B
PIN # 1 I.D.
0.35x45
E/2
E2/2
C
(NE-1) X
e
L
E2
E
k
L
DETAIL A
e
(ND-1) X
e
C
C
L
L
L
L
e
e
0.10
C
A
0.08
C
C
A3
A1
PROPRIETARY INFORMATION
TITLE:
PACKAGE OUTLINE
16, 20, 28, 32L, QFN THIN, 5x5x0.8 mm
APPROVAL
DOCUMENT CONTROL NO.
REV.
1
21-0140
C
2
COMMON DIMENSIONS
EXPOSED PAD VARIATIONS
NOTES:
1. DIMENSIONING & TOLERANCING CONFORM TO ASME Y14.5M-1994.
2. ALL DIMENSIONS ARE IN MILLIMETERS. ANGLES ARE IN DEGREES.
3. N IS THE TOTAL NUMBER OF TERMINALS.
4. THE TERMINAL #1 IDENTIFIER AND TERMINAL NUMBERING CONVENTION SHALL CONFORM TO JESD 95-1
SPP-012. DETAILS OF TERMINAL #1 IDENTIFIER ARE OPTIONAL, BUT MUST BE LOCATED WITHIN THE
ZONE INDICATED. THE TERMINAL #1 IDENTIFIER MAY BE EITHER A MOLD OR MARKED FEATURE.
5. DIMENSION b APPLIES TO METALLIZED TERMINAL AND IS MEASURED BETWEEN 0.25 mm AND 0.30 mm
FROM TERMINAL TIP.
6. ND AND NE REFER TO THE NUMBER OF TERMINALS ON EACH D AND E SIDE RESPECTIVELY.
7. DEPOPULATION IS POSSIBLE IN A SYMMETRICAL FASHION.
8. COPLANARITY APPLIES TO THE EXPOSED HEAT SINK SLUG AS WELL AS THE TERMINALS.
9. DRAWING CONFORMS TO JEDEC MO220.
PROPRIETARY INFORMATION
TITLE:
PACKAGE OUTLINE
10. WARPAGE SHALL NOT EXCEED 0.10 mm.
16, 20, 28, 32L, QFN THIN, 5x5x0.8 mm
APPROVAL
DOCUMENT CONTROL NO.
REV.
2
21-0140
C
2
18 ______________________________________________________________________________________
MAXIM [ MAXIM INTEGRATED PRODUCTS ]
