FAST BOOT BLOCK DATASHEET
E
8.0 ELECTRICAL SPECIFICATIONS
NOTICE: This datasheet contains preliminary
information on products in the design phase of
development. The specifications are subject to
change without notice. Verify with your local Intel
Sales office that you have the latest datasheet
before finalizing a design.
8.1
Absolute Maximum Ratings*
Temperature under Bias ............ –40 °C to +125 °C
Storage Temperature................. –65 °C to +125 °C
*WARNING: Stressing the device beyond the
“Absolute Maximum Ratings” may cause permanent
damage. These are stress ratings only. Operation
beyond the “Operating Conditions” is not
recommended and extended exposure beyond the
“Operating Conditions” may affect device reliability.
Voltage On Any Pin
(except VCC, VCCQ, and VPP)–0.5 V to +5.5 V(1)
VPP Voltage .........................–0.5 V to +13.5 V(1,2,4)
VCC and VCCQ Voltage............... –0.2 V to +5.0 V(1)
Output Short Circuit Current.....................100 mA(3)
NOTES:
1. All specified voltages are with respect to GND. Minimum DC voltage is–0.5 V on input/output pins and –0.2 V on VCC and
VPP pins. During transitions, this level may undershoot to–2.0 V for periods <20 ns. Maximum DC voltage on input/output
pins and VCC is VCC +0.5 V which, during transitions, may overshoot to VCC +2.0 V for periods <20 ns.
2. Maximum DC voltage on VPP may overshoot to +14.0 V for periods <20 ns.
3. Output shorted for no more than one second. No more than one output shorted at a time.
4. VPP Program voltage is normally 2.7 V–3.6 V. Connection to supply of 11.4 V–12.6 V can only be done for 1000 cycles on
the main blocks and 2500 cycles on the parameter blocks during program/erase. V may be connected to 12 V for a total
PP
of 80 hours maximum.
8.2
Extended Temperature Operating Conditions
Symbol
Parameter
Operating Temperature
VCC Supply Voltage
VCC Supply Voltage
VCC Supply Voltage
I/O Voltage
Notes
Min
–40
2.7
Max
+85
2.85
3.3
Unit
TA
°C
VCC1
VCC2
VCC3
VCCQ1
VCCQ2
VCCQ3
VPPH1
VPPH2
1
1
V
2.7
V
1,4
1,2
1,2
1,2,4
1
2.7
3.6
V
1.65
1.8
2.5
V
I/O Voltage
2.5
V
I/O Voltage
2.7
3.6
V
V
VPP Supply Voltage
VPP Supply Voltage
Block Erase Cycling
2.7
3.6
1,4
3
11.4
10,000
12.6
V
Cycling
Cycles
NOTES:
1. See DC Characteristics tables for voltage range-specific specifications.
2. The voltage swing on the inputs, VIN is required to match VCCQ
.
3. Applying VPP = 11.4 V–12.6 V during a program or erase can only be done for a maximum of 1000 cycles on the main
blocks and 2500 cycles on the parameter blocks. A hard connection to VPP = 11.4 V–12.6 V is not allowed and can cause
damage to the device.
4. VCC, VCCQ, and VPP1 must share the same supply when all three are between 2.7V and 3.6 V.
28
PRODUCT PREVIEW
INTEL [ INTEL ]
