IBMN325164CT3
IBMN325804CT3
IBMN325404CT3
Preliminary
256Mb Synchronous DRAM - Die Revision B
Write Interrupted by a Read
A Read Command will interrupt a burst write operation on the same clock cycle that the Read Command is
registered. The DQs must be in the high impedance state at least one cycle before the interrupting read data
appears on the outputs to avoid data contention. When the Read Command is registered, any residual data
from the burst write cycle will be ignored. Data that is presented on the DQ pins before the Read Command is
initiated will actually be written to the memory.
Minimum Write to Read Interval
(Burst Length = 4, CAS latency = 2, 3)
T0
T1
T2
T3
T4
T5
T6
T7
T8
CK
WRITE A
READ B
NOP
NOP
NOP
NOP
NOP
NOP
NOP
COMMAND
CAS latency = 2
DIN A
0
DOUT B
0
DOUT B
DOUT B
DOUT B
DOUT B
DOUT B
DOUT B
1
2
3
tCK2, DQs
CAS latency = 3
DIN A
0
DOUT B
3
0
1
2
tCK3, DQs
: “H” or “L”
Input data for the Write is masked.
Input data must be removed from the DQs at least one clock
cycle before the Read data appears on the outputs to avoid
data contention.
©IBM Corporation. All rights reserved.
Use is further subject to the provisions at the end of this document.
06K0608.F39375A
10/00
Page 15 of 66