11
1Gbit (32Mx32bit) Mobile SDR Memory
H55S1G(2/3)2MFP Series
BURST TERMINATE
The BURST TERMINATE command is used to truncate read bursts (with autoprecharge disabled). The most recently
registered READ command prior to the BURST TERMINATE command will be truncated, as shown in the Operation sec-
tion of this datasheet. Note the BURST TERMINATE command is not bank specific. This command should not be used
to terminate write bursts.
The below figure shows in case of 2KByte page size. If the page size is 4KByte, A0~A12 are provided.
CLK
CKE
(High)
CS
RAS
CAS
WE
A0 ~ A13
BA0, 1
Don't Care
BURST TERMINATE COMMAND
Rev 1.2 / Jun. 2008
38