GS9060 Data Sheet
the SDID is set to zero, the device will detect all ancillary data types matching the
DID value, regardless of the SDID.
In the case where all five DID and SDID values are set to zero, the GS9060 will
detect all ancillary data types. This is the default setting after device reset.
Where one or more, but less than five, DID and/or SDID values have been
programmed, then only those matching ancillary data types will be detected and
indicated.
NOTE 1: The GS9060 will always detect EDH ancillary data packets for EDH error
detection purposes, regardless of which DID/SDID values have been programmed
for ancillary data indication, Section 3.10.5.2 on page 44.
NOTE 2: See SMPTE 291M for a definition of ancillary data terms.
Table 3-4: Host Interface Description for Programmable Ancillary Data Type Registers
Register
Name
Bit
Name
Description
R/W
Default
ANC_TYPE1
Address: 05h
15-8
7-0
ANC_TYPE1[15:8]
ANC_TYPE1[7:0]
Used to program the DID for ancillary data detection at the
YANC and CANC output
R/W
R/W
0
0
Used to program the SDID for ancillary data detection at
the YANC and CANC output.
Should be set to zero if no SDID is present in the ancillary
data packet to be detected.
ANC_TYPE2
Address: 06h
15-8
7-0
ANC_TYPE2[15:8]
ANC_TYPE2[7:0]
Used to program the DID for ancillary data detection at the
YANC and CANC output
R/W
R/W
0
0
Used to program the SDID for ancillary data detection at
the YANC and CANC output.
Should be set to zero if no SDID is present in the ancillary
data packet to be detected.
ANC_TYPE3
Address: 07h
15-8
7-0
ANC_TYPE3[15:8]
ANC_TYPE3[7:0]
Used to program the DID for ancillary data detection at the
YANC and CANC output
R/W
R/W
0
0
Used to program the SDID for ancillary data detection at
the YANC and CANC output.
Should be set to zero if no SDID is present in the ancillary
data packet to be detected.
ANC_TYPE4
Address: 08h
15-8
7-0
ANC_TYPE4[15:8]
ANC_TYPE4[7:0]
Used to program the DID for ancillary data detection at the
YANC and CANC output
R/W
R/W
0
0
Used to program the SDID for ancillary data detection at
the YANC and CANC output.
Should be set to zero if no SDID is present in the ancillary
data packet to be detected.
ANC_TYPE5
Address: 09h
15-8
7-0
ANC_TYPE5[15:8]
ANC_TYPE5[7:0]
Used to program the DID for ancillary data detection at the
YANC and CANC output
R/W
R/W
0
0
Used to program the SDID for ancillary data detection at
the YANC and CANC output.
Should be set to zero if no SDID is present in the ancillary
data packet to be detected.
22208 - 8 January 2007
38 of 61
GENNUM [ GENNUM CORPORATION ]
