Document Reference No.: FT_000327
Vinculo Development Module Datasheet Version 1.0
Clearance No.: FTDI#173
3.3 USB Slave Port : Pins and Signal Description
Connector CN3 is a USB mini-B, designed for connecting to USB hosts. This connector routes to the
VNC2-64Q USB port 1 and the firmware on the VNC2-64Q should be written to ensure it is in slave mode.
The port is USB 2.0 full speed compliant.
This port can also be used to provide power to the Vinculo with 5V at 500mA max.
Pin No.
Signal
5V (can be used to
power PCB or disabled
with JP1)
USB DM
USB DP
Not connected
GND
1
2
3
4
5
Table 3.2 - USB Slave Pin Out
3.4 USB Host Port : Pins and Signal Description
Connector CN2 is a USB type A connector designed for connecting to USB devices. This connector routes
to the VNC2-64Q USB port 2 and the firmware on the VNC2-64Q should be written to ensure it is in host
mode.
The port is USB 2.0 full speed compliant.
Pin No.
Signal
5V supply to
peripheral device.
Enabled by the VNC2-
64Q
USB DM
USB DP
GND
1
2
3
4
Table 3.3 - USB Slave Pin Out
Copyright © 2010 Future Technology Devices International Limited
7