128 KByte Flash Module (S12FTMRC128K1V1)
Table 13-14. FSTAT Field Descriptions (continued)
Field
Description
3
Memory Controller Busy Flag — The MGBUSY flag reflects the active state of the Memory Controller.
0 Memory Controller is idle
MGBUSY
1 Memory Controller is busy executing a Flash command (CCIF = 0)
2
Reserved Bit — This bit is reserved and always reads 0.
RSVD
1–0
Memory Controller Command Completion Status Flag — One or more MGSTAT flag bits are set if an error
MGSTAT[1:0] is detected during execution of a Flash command or during the Flash reset sequence. See Section 13.4.5,
“Flash Command Description,” and Section 13.6, “Initialization” for details.
13.3.2.8 Flash Error Status Register (FERSTAT)
The FERSTAT register reflects the error status of internal Flash operations.
Offset Module Base + 0x0007
7
6
5
4
3
2
1
0
R
W
0
0
0
0
0
0
DFDIF
SFDIF
Reset
0
0
0
0
0
0
0
0
= Unimplemented or Reserved
Figure 13-12. Flash Error Status Register (FERSTAT)
All flags in the FERSTAT register are readable and only writable to clear the flag.
Table 13-15. FERSTAT Field Descriptions
Field
Description
1
Double Bit Fault Detect Interrupt Flag — The setting of the DFDIF flag indicates that a double bit fault was
detected in the stored parity and data bits during a Flash array read operation or that a Flash array read operation
was attempted on a Flash block that was under a Flash command operation.(1) The DFDIF flag is cleared by
writing a 1 to DFDIF. Writing a 0 to DFDIF has no effect on DFDIF.
DFDIF
0 No double bit fault detected
1 Double bit fault detected or an invalid Flash array read operation attempted
0
Single Bit Fault Detect Interrupt Flag — With the IGNSF bit in the FCNFG register clear, the SFDIF flag
indicates that a single bit fault was detected in the stored parity and data bits during a Flash array read operation
or that a Flash array read operation was attempted on a Flash block that was under a Flash command operation.1
The SFDIF flag is cleared by writing a 1 to SFDIF. Writing a 0 to SFDIF has no effect on SFDIF.
0 No single bit fault detected
SFDIF
1 Single bit fault detected and corrected or an invalid Flash array read operation attempted
1. The single bit fault and double bit fault flags are mutually exclusive for parity errors (an ECC fault occurrence can be either
single fault or double fault but never both). A simultaneous access collision (read attempted while command running) is
indicated when both SFDIF and DFDIF flags are high.
13.3.2.9 P-Flash Protection Register (FPROT)
The FPROT register defines which P-Flash sectors are protected against program and erase operations.
S12P-Family Reference Manual, Rev. 1.13
440
Freescale Semiconductor
FREESCALE [ Freescale ]
