Register Descriptions
5.6.1
Interrupt Priority Register 0 (IPR0)
Base + $0
Read
15
14
0
13
12
0
11
0
10
0
9
8
7
6
5
4
3
2
1
0
PLL IPL
LVI IPL
RX_REG IPL TX_REG IPL
TRBUF IPL
BKPT_U IPL STPCNT IPL
Write
RESET
0
0
0
0
0
0
0
0
0
0
0
0
0
0
Figure 5-3 Interrupt Priority Register 0 (IPR0)
5.6.1.1
PLL Loss of Reference or Change in Lock Status Interrupt Priority Level
(PLL IPL)—Bits 15–14
This field is used to set the interrupt priority levels for the PLL Loss of Reference or Change in Lock Status
IRQ. This IRQ is limited to priorities 1 through 3. It is disabled by default.
•
•
•
•
00 = IRQ disabled (default)
01 = IRQ is priority level 1
10 = IRQ is priority level 2
11 = IRQ is priority level 3
5.6.1.2
Low Voltage Detector Interrupt Priority Level (LVI IPL)—Bits 13–12
This field is used to set the interrupt priority levels for the Low Voltage Detector IRQ. This IRQ is limited
to priorities 1 through 3 and is disabled by default.
•
•
•
•
00 = IRQ disabled (default)
01 = IRQ is priority level 1
10 = IRQ is priority level 2
11 = IRQ is priority level 3
5.6.1.3
Reserved—Bits 11–10
This bit field is reserved. Each bit must be set to 0.
5.6.1.4
EOnCE Receive Register Full Interrupt Priority Level
(RX_REG IPL)— Bits 9–8
This field is used to set the interrupt priority level for the EOnCE Receive Register Full IRQ. This IRQ is
limited to priorities 1 through 3. It is disabled by default.
•
•
•
•
00 = IRQ disabled (default)
01 = IRQ is priority level 1
10 = IRQ is priority level 2
11 = IRQ is priority level 3
56F8036 Data Sheet, Rev. 6
Freescale Semiconductor
61
FREESCALE [ Freescale ]
