XBee®/XBee‐PRO® ZB SMT RF Modules
Canada (IC)
Labeling Requirements
Labeling requirements for Industry Canada are similar to those of the FCC. A clearly visible label on the
outside of the final product enclosure must display the following text:
Contains Model XBee Radio, IC: 1846A-XBS2C
The integrator is responsible for its product to comply with IC ICES-003 & FCC Part 15, Sub. B -
Unintentional Radiators. ICES-003 is the same as FCC Part 15 Sub. B and Industry Canada accepts FCC
test report or CISPR 22 test report for compliance with ICES-003.
If it contains an XBee-PRO RF Module, the clearly visible label on the outside of the final product
enclosure must display the following text:
Contains Model XBee PRO Radio, IC: 1846A-XBPS2C
Transmitters for Detachable Antennas
This device has been designed to operate with the antennas listed in the previous table and having a
maximum of 19 dB. Antennas not included in this list or having a gain greater than 19 dB are strictly
prohibited for use with this device. The required antenna impedance is 50 ohms.
Detachable Antenna
To reduce potential radio interference to other users, the antenna type and gain should be so chosen that
the equivalent, istropically radiated power (EIRP) is not more than permitted for successful communication.
Australia (C-Tick)
These modules comply with requirements to be used in end products in Australia. All products with EMC
and radio communications must have a registered C-Tick mark. Registration to use the compliance mark
will only be accepted from Australian manufacturers or importers, or their agent, in Australia.
In order to have a C-Tick mark on an end product, a company must comply with a or b below.
a. have a company presence in Australia.
b. have a company/distributor/agent in Australia that will sponsor the importing of the end
product.
Contact Digi for questions related to locating a contact in Australia.
© 2010 Digi International, Inc.
146
DCD [ DIGITAL CORE DESIGN ]
