XBee®/XBee‐PRO® ZB SMT RF Modules
OEM Labeling Requirements
The 'CE' marking must be affixed to a visible location on the OEM product.
CE Labeling Requirements
The CE mark shall consist of the initials "CE" taking the following form:
•If the CE marking is reduced or enlarged, the proportions given in the above graduated drawing must
be respected.
•The CE marking must have a height of at least 5mm except where this is not possible on account of
the nature of the apparatus.
•The CE marking must be affixed visibly, legibly, and indelibly.
Restrictions
France: Outdoor use limited to 10 mW EIRP within the band 2454-2483.5 MHz.
Norway: Norway prohibits operation near Ny-Alesund in Svalbard. More information can be found at the
Norway Posts and Telecommunications site (www.npt.no).
Italy: For private use, a general authorization is required if WAS/RLANs are used outside own premises.
For public use, a general authorization is required.
Russian Federation:
• Maximum mean EIRP density is 2 mW/MHz, maximum 100 mW EIRP.
• Maximum mean EIRP density is 20 mW/MHz, maximum 100 mW EIRP permitted to use SRD
for outdoor applications only, for purposes of gathering telemetry information for automated
monitoring and resources accounting systems or security systems.
• Maximum mean EIRP density is 10 mW/MHz, maximum 100 mW EIRP for indoor applications.
Ukraine: EIRP must be less than or equal to 100 mW with built-in antenna, with amplification factor up to
6 dBi.
Declarations of Conformity
Digi has issued Declarations of Conformity for the XBee RF Modules concerning emissions, EMC and safety.
Files can be obtained by contacting Digi Support.
Important Note:
Digi does not list the entire set of standards that must be met for each country. Digi customers assume full
responsibility for learning and meeting the required guidelines for each country in their distribution market.
For more information relating to European compliance of an OEM product incorporating the XBee RF
Module, contact Digi, or refer to the following web sites:
CEPT ERC 70-03E - Technical Requirements, European restrictions and general requirements: Available at
www.ero.dk/.
R&TTE Directive - Equipment requirements, placement on market: Available at www.ero.dk/.
XBee RF Module
The following antennas have been tested and approved for use with the embedded XBee RF Module:
- Dipole (2.1 dBi, Omni-directional, Articulated RPSMA, Digi part number A24-HABSM)
- PCB Antenna (0.0 dBi)
- Monopole Whip (1.5 dBi)
© 2010 Digi International, Inc.
145
DCD [ DIGITAL CORE DESIGN ]
