CYW43362
11. WLAN RF Specifications
The CYW43362 includes an integrated direct conversion radio that supports the 2.4 GHz band. This section describes the RF char-
acteristics of the 2.4 GHz radio.
Note: Values in this document are design goals and may change based on device characterization results.
Unless otherwise stated, the specifications in this section apply when the operating conditions are within the limits specified in
Table 13, “Environmental Ratings,” on page 41 and Table 15, “Recommended Operating Conditions and DC Characteristics,” on
page 42. Functional operation outside these limits is not guaranteed.
Typical values apply for the following conditions:
■
VBAT = 3.6V
■
Ambient temperature +25°C
Figure 23. RF Port Location
CYW43362
T/R RF Switch
(0.5 dB Insertion Loss)
WLAN Tx
Filter
WLAN Rx
Antenna
Port
RF Port
Chip
Port
Note: All specifications are measured at the RF port unless otherwise specified.
11.1 2.4 GHz Band General RF Specifications
Table 16. 2.4 GHz Band General RF Specifications
Item
Condition
Minimum
Typical
Maximum
Unit
Tx/Rx switch time
Rx/Tx switch time
Including TX ramp down
Including TX ramp up
–
–
–
–
µs
µs
5
2
11.2 WLAN 2.4 GHz Receiver Performance Specifications
Note: The specifications in Table 17 are measured at the RF port.
Table 17. WLAN 2.4 GHz Receiver Performance Specifications
Parameter
Condition/Notes
Minimum Typical Maximum
Unit
Frequency range
Operating temperature
–
–
2400
–30
–
2500
85
MHz
°C
25
Document No. 002-14779 Rev. *G
Page 43 of 60
CYPRESS [ CYPRESS ]
