ATmega8(L)
Parallel
This section describes how to parallel program and verify Flash Program memory, EEPROM
Data memory, Memory Lock Bits, and Fuse Bits in the ATmega8. Pulses are assumed to be at
least 250ns unless otherwise noted.
Programming
Parameters, Pin
Mapping, and
Commands
Signal Names
In this section, some pins of the ATmega8 are referenced by signal names describing their func-
tionality during parallel programming, see Figure 104 and Table 91. Pins not described in the
following table are referenced by pin names.
The XA1/XA0 pins determine the action executed when the XTAL1 pin is given a positive pulse.
The bit coding is shown in Table 93 on page 220.
When pulsing WR or OE, the command loaded determines the action executed. The different
Commands are shown in Table 94 on page 220.
Figure 104. Parallel Programming
+5V
RDY/BSY
OE
PD1
PD2
PD3
PD4
PD5
PD6
PD7
VCC
+5V
AVCC
WR
BS1
PC[1:0]:PB[5:0]
DATA
XA0
XA1
PAGEL
+12 V
BS2
RESET
PC2
XTAL1
GND
Table 91. Pin Name Mapping
Signal Name in
Programming Mode
Pin Name
I/O Function
0: Device is busy programming, 1: Device
is ready for new command
RDY/BSY
PD1
O
OE
PD2
PD3
I
I
Output Enable (Active low)
Write Pulse (Active low)
WR
Byte Select 1 (“0” selects Low byte, “1”
selects High byte)
BS1
PD4
I
XA0
XA1
PD5
PD6
I
I
XTAL Action Bit 0
XTAL Action Bit 1
219
2486AA–AVR–02/2013
ATMEL [ ATMEL ]
