Revision 1.29 – May 07, 2008
440EP – PPC440EP Embedded Processor
Data Sheet
Figure 4. Overshoot Waveform
AC Overshoot (V)
DC Overshoot (V)
T
CYC
DC Undershoot (V)
AC Undershoot (V)
T
T
OS
OS
Table 11. Overshoot and Undershoot
TOS
Receiver
3.3V LVTTL
AC Overshoot (V)
DC Overshoot (V)
DC Undershoot (V)
AC Undershoot (V)
1
1
3.9
3.6
0
-0.6
-0.6
0.1*TCYC
0.1*TCYC
2.5V (3.3V tolerant)
3.9
3.6
0
0
0
1.2*SOVDD
1.2*OVDD
SOVDD + 0.3
OVDD + 0.5
DDR
PCI
-0.6
0.1/MemClkOut
0.1/PCIClk
-0.2*OVDD
Notes:
1. T
is the period of the bus clock.
CYC
1/PerClk - EBC and NAND flash interfaces.
1/EMCRXClk - MII mode
1/EMCRefclk - RMII mode
1/SMIIRefClk - SMII mode
1/USB2Clk - UTMI
1/TrcClk - instruction trace interface
1/IIC0Clk and 1/IIC1Clk - IIC interfaces
1/SPIClkOut - SPI
Power Sequencing
Startup sequencing of the power supply voltages is not required. However, a power-down cycle must complete
(OV and V are below +0.4V) before a new power-up cycle is started.
DD
DD
Analog Voltage Filter
The analog voltages used for the on-chip PLLs can be derived from the logic voltage, but must be filtered before entering the
PPC440EP. A Separate filter, as shown below, is recommended for each voltage.
• The filter should keep the AV -AGND (SAGND-SAGND) compression/expansion due to noise less than +50
DD
mV.
AMCC Proprietary
63
AMCC [ APPLIED MICRO CIRCUITS CORPORATION ]
