MAX 9000 Programmable Logic Device Family Data Sheet
The VCCIOpins can be connected to either a 3.3-V or 5.0-V power supply,
depending on the output requirements. When the VCCIOpins are
connected to a 5.0-V power supply, the output levels are compatible with
5.0-V systems. When the VCCIOpins are connected to a 3.3-V power
supply, the output high is at 3.3 V and is therefore compatible with 3.3-V
or 5.0-V systems. Devices operating with VCCIO levels lower than 4.75 V
incur a nominally greater timing delay of tOD2 instead of tOD1
.
MAX 9000 devices can be programmed in-system through a 4-pin JTAG
interface. ISP offers quick and efficient iterations during design
development and debug cycles. The MAX 9000 architecture internally
generates the 12.0-V programming voltage required to program EEPROM
cells, eliminating the need for an external 12.0-V power supply to program
the devices on the board. During ISP, the I/ O pins are tri-stated to
eliminate board conflicts.
In-System
Programma-
bility (ISP)
ISP simplifies the manufacturing flow by allowing the devices to be
mounted on a printed circuit board with standard pick-and-place
equipment before they are programmed. MAX 9000 devices can be
programmed by downloading the information via in-circuit testers,
embedded processors, or the Altera BitBlaster, ByteBlaster, or
ByteBlasterMV download cable. (The ByteBlaster cable is obsolete and has
been replaced by the ByteBlasterMV cable, which can interface with 2.5-V,
3.3-V, and 5.0-V devices.) Programming the devices after they are placed
on the board eliminates lead damage on high pin-count packages (e.g.,
QFP packages) due to device handling. MAX 9000 devices can also be
reprogrammed in the field (i.e., product upgrades can be performed in the
field via software or modem).
In-system programming can be accomplished with either an adaptive or
constant algorithm. An adaptive algorithm reads information from the
unit and adapts subsequent programming steps to achieve the fastest
possible programming time for that unit. Because some in-circuit testers
platforms have difficulties supporting an adaptive algorithm, Altera
offers devices tested with a constant algorithm. Devices tested to the
constant algorithm have an “F” suffix in the ordering code.
Altera Corporation
19
ALTERA [ ALTERA CORPORATION ]
