ADV7180
PFTOGDELO, PAL Field Toggle Delay on Odd Field,
Address 0xEA [7]
1
PVENDSIGN
0
When PFTOGDELO is 0 (default), there is no delay.
ADVANCE END OF
DELAY END OF VSYNC
BY PVEND[4:0]
VSYNC BY PVEND[4:0]
Setting PFTOGDELO to 1 delays the F toggle/transition on an
odd field by a line relative to PFTOG.
NOT VALID FOR USER
PROGRAMMING
PFTOGDELE, PAL Field Toggle Delay on Even Field,
Address 0xEA [6]
ODD FIELD?
YES
NO
When PFTOGDELE is 0, there is no delay.
Setting PFTOGDELE to 1 (default) delays the F toggle/transition
on an even field by a line relative to PFTOG.
PVENDDELO
1
PVENDDELE
1
PFTOGSIGN, PAL Field Toggle Sign, Address 0xEA [5]
0
0
Setting PFTOGSIGN to 0 delays the field transition. Set for user
manual programming.
ADDITIONAL
DELAY BY
1 LINE
ADDITIONAL
DELAY BY
1 LINE
Setting PFTOGSIGN to 1 (default) advances the field transition.
Not recommended for user programming.
PFTOG, PAL Field Toggle, Address 0xEA [4:0]
VSEHO
1
VSEHE
1
The default value of PFTOG is 00011, indicating the PAL field
toggle position.
0
0
For all NTSC/PAL field timing controls, the F bit in the AV
code and the field signal on the FIELD/DE pin are modified.
ADVANCE BY
0.5 LINE
ADVANCE BY
0.5 LINE
1
PFTOGSIGN
0
VSYNC END
ADVANCE TOGGLE OF
FIELD BY PFTOG[4:0]
DELAY TOGGLE OF
FIELD BY PFTOG[4:0]
Figure 41. PAL Vsync End
PVENDDELO, PAL Vsync End Delay on Odd Field,
Address 0xE9 [7]
NOT VALID FOR USER
PROGRAMMING
ODD FIELD?
When PVENDDELO is 0 (default), there is no delay.
YES
NO
Setting PVENDDELO to 1 delays vsync going low on an odd
field by a line relative to PVEND.
PFTOGDELO
1
PFTOGDELE
1
PVENDDELE, PAL Vsync End Delay on Even Field,
Address 0xE9 [6]
0
0
When PVENDDELE is 0 (default), there is no delay.
ADDITIONAL
DELAY BY
1 LINE
ADDITIONAL
DELAY BY
1 LINE
Setting PVENDDELE to 1 delays vsync going low on an even
field by a line relative to PVEND.
PVENDSIGN, PAL Vsync End Sign, Address 0xE9 [5]
Setting PVENDSIGN to 0 (default) delays the end of vsync. Set
for user manual programming.
FIELD
TOGGLE
Figure 42. PAL F Toggle
Setting PVENDSIGN to 1 advances the end of vsync. Not
recommended for user programming.
PVEND[4:0], PAL Vsync End, Address 0xE9 [4:0]
The default value of PVEND is 10100, indicating the PAL vsync
end position.
For all NTSC/PAL vsync timing controls, both the V bit in the
AV code and the vsync on the VS pin are modified.
Rev. A | Page 49 of 112
ADI [ ADI ]
