NT5DS32M4AT
NT5DS16M8AT
128Mb Double Data Rate SDRAM
Truth Table 3: Current State Bank n - Command to Bank n (Same Bank)
Current State
Any
CS
H
RAS
X
CAS
X
WE
X
Command
Deselect
Action
Notes
1-6
NOP. Continue previous operation
NOP. Continue previous operation
L
H
H
H
No Operation
1-6
L
L
L
L
L
L
L
L
L
L
L
L
L
H
L
H
H
L
Active
Auto Refresh
Mode Register Set
Read
Select and activate row
1-6
1-7
Idle
L
L
L
1-7
H
H
L
L
H
L
Select column and start Read burst
Select column and start Write burst
Deactivate row in bank(s)
1-6, 10
1-6, 10
1-6, 8
Row Active
L
Write
H
L
L
Precharge
Read
H
L
H
L
Select column and start new Read burst
Truncate Read burst, start Precharge
Burst Terminate
1-6, 10
1-6, 8
Read
(Auto Precharge
Disabled)
H
H
L
Precharge
Burst Terminate
Read
H
H
H
L
L
1-6, 9
H
L
Select column and start Read burst
Select column and start Write burst
Truncate Write burst, start Precharge
1-6, 10, 11
1-6, 10
1-6, 8, 11
Write
(Auto Precharge
Disabled)
L
Write
H
L
Precharge
1. This table applies when CKE n-1 was high and CKE n is high (see Truth Table 2: Clock Enable (CKE) and after t
met (if the previous state was self refresh).
t
has been
XSNR / XSRD
2. This table is bank-specific, except where noted, i.e., the current state is for a specific bank and the commands shown are those allowed
to be issued to that bank when in that state. Exceptions are covered in the notes below.
3. Current state definitions:
Idle:
The bank has been precharged, and t
has been met.
RP
Row Active:
A row in the bank has been activated, and t
progress.
has been met. No data bursts/accesses and no register accesses are in
RCD
Read:
Write:
A Read burst has been initiated, with Auto Precharge disabled, and has not yet terminated or been terminated.
A Write burst has been initiated, with Auto Precharge disabled, and has not yet terminated or been terminated.
4. The following states must not be interrupted by a command issued to the same bank.
Precharging:
Starts with registration of a Precharge command and ends when t
state.
is met. Once t
is met, the bank is in the idle
is met, the bank is in the “ row
R P
RP
Row Activating: Starts with registration of an Active command and ends when t
active” state.
is met. Once t
RCD
RCD
Read w/Auto Precharge Enabled: Starts with registration of a Read command with Auto Precharge enabled and ends when t
has been
RP
met. Once t
is met, the bank is in the idle state.
RP
Write w/Auto Precharge Enabled: Starts with registration of a Write command with Auto Precharge enabled and ends when t has been
RP
met. Once t
is met, the bank is in the idle state.
RP
Deselect or NOP commands, or allowable commands to the other bank should be issued on any clock edge occurring during these
states. Allowable commands to the other bank are determined by its current state and according to Truth Table 4.
5. The following states must not be interrupted by any executable command; Deselect or NOP commands must be applied on each positive
clock edge during these states.
Refreshing:
Starts with registration of an Auto Refresh command and ends when t
in the “ all banks idle” state.
is met. Once t
is met, the DDR SDRAM is
RFC
RFC
Accessing Mode Register: Starts with registration of a Mode Register Set command and ends when t
met, the DDR SDRAM is in the “ all banks idle” state.
has been met. Once t
is
MRD
MRD
Precharging All: Starts with registration of a Precharge All command and ends when t
state.
is met. Once t
is met, all banks is in the idle
RP
RP
6. All states and sequences not shown are illegal or reserved.
7. Not bank-specific; requires that all banks are idle.
8. May or may not be bank-specific; if all/any banks are to be precharged, all/any must be in a valid state for precharging.
9. Not bank-specific; Burst terminate affects the most recent Read burst, regardless of bank.
10. Reads or Writes listed in the Command/Action column include Reads or Writes with Auto Precharge enabled and Reads or Writes with
Auto Precharge disabled.
11. Requires appropriate DM masking.
46
REV 1.0
May, 2001
©
NANYA TECHNOLOGY CORP. All rights reserved.
NANYA TECHNOLOGY CORP. reserves the right to change Products and Specifications without notice.
ETC [ ETC ]
