CXD3018Q/R
$7X commands
Auto sequence track jump/move count setting (N)
Data 2
Data 1
Data 3
Data 4
Command
D3 D2 D1 D0 D3 D2 D1 D0 D3 D2 D1 D0 D3 D2 D1 D0
215 214 213 212 211 210 29 28 27 26 25 24 23 22 21 20
Auto sequence track jump
count setting
This command is used to set N when a 2N-track jump or N-track move is executed for auto sequence.
• The maximum track count is 65,535, but note that with a 2N-track jump the maximum track jump count
depends on the mechanical limitations of the optical system.
• The number of tracks jumped is counted according to the COUT signals.
$8X commands
Data 1
D2 D1
Data 2
Data 3
D2 D1
Command
D3
D0
D3
D2
D1
D0
D3
D0
DOUT DOUT
Mute ON/OFF
VCO
SEL1
VCO
SEL2
Mode
specification
CDROM
WSEL
0
SOCT
KSL3 KSL2 KSL1 KSL0
See "$BX Commands".
Data 4
Data 5
Data 6
D3
0
D2
D1
D0
0
D3
0
D2
D1
D0
0
D3
D2
D1
D0
VCO1 VCO2
CS0 THRU
0
0
TXON TXOUT OUTL1 OUTL0
Command bit
C2PO timing
Processing
See Timing
Chart 1-1.
CDROM mode; average value interpolation and previous value
hold are not performed.
CDROM = 1
CDROM = 0
See Timing
Chart 1-1.
Audio mode; average value interpolation and previous value
hold are performed.
Command bit
DOUT Mute = 1
DOUT Mute = 0
Processing
Digital Out output is muted. (DA output is not muted.)
If other mute conditions are not set, Digital Out is not muted.
Command bit
Processing
Digital Out is output from the DOUT pin.
Digital Out is not output from the DOUT pin.
DOUT ON/OFF = 1
DOUT ON/OFF = 0
– 35 –
ETC [ ETC ]
