Z8F640x/Z8F480x/Z8F320x/Z8F240x/Z8F160x
Z8 Encore!®
90
CTSE—CTS Enable
0 = The CTS signal has no effect on the transmitter.
1 = The UART recognizes the CTS signal as an enable control from the transmitter.
PEN—Parity Enable
This bit enables or disables parity. Even or odd is determined by the PSELbit.
0 = Parity is disabled.
1 = The transmitter sends data with an additional parity bit and the receiver receives an
additional parity bit.
PSEL—Parity Select
0 = Even parity is transmitted and expected on all received data.
1 = Odd parity is transmitted and expected on all received data.
SBRK—Send Break
This bit pauses or breaks data transmission. Sending a break interrupts any transmission in
progress, so insure that the transmitter has finished sending data before setting this bit.
0 = No break is sent.
1 = The output of the transmitter is zero.
STOP—Stop Bit Select
0 = The transmitter sends one stop bit.
1 = The transmitter sends two stop bits.
LBEN—Loop Back Enable
0 = Normal operation.
1 = All transmitted data is looped back to the receiver.
Table 55. UARTx Control 1 Register (UxCTL1)
BITS
FIELD
RESET
R/W
7
6
5
4
3
2
1
0
BIRQ
MPM
MPE
MPBT
Reserved
RDAIRQ
IREN
0
0
0
0
0
0
0
0
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
F43H and F4BH
ADDR
BIRQ—Baud Rate Generator Interrupt Request
This bit sets an interrupt request when the Baud Rate Generator times out and is only set if
a UART is not enabled. The is bit produces no effect when the UART is enabled.
0 = Interrupts behave as set by UART control.
1 = The Baud Rate Generator generates a receive interrupt when it counts down to zero.
MPM—Multiprocessor (9-bit) mode Select
This bit is used to enable Multiprocessor (9-bit) mode.
PS017610-0404
UART
ZILOG [ ZILOG, INC. ]
