Z8018x Family
MPU User Manual
81
also the interrupt response sequence used for all internal interrupts
(except TRAP).
As depicted in Figure 41, the low-order byte of the vector table address
has the most significant three bits of the software programmable IL
register while the least significant five bits are a unique fixed value for
each interrupt (INT1, INT2 and internal) source:
Memory
16-bit Vector
Fixed Code
I
IL
(5 bits)
High-order 8 bits
of starting address
Vector + 1
Vector
32 Bytes
Vector
Table
Low-order 8 bits
of starting address
Figure 41. INT1, INT2 Vector Acquisition
INT1 and INT2 are globally masked by IEF1 is 0. Each is also
individually maskable by respectively clearing the ITE1 and ITE2 (bits
1,2) of the INT/TRAP control register to 0.
During RESET, IEF1, ITE1 and ITE2 bits are reset to 0.
Internal Interrupts
Internal interrupts (except TRAP) use the same vectored response mode
as INT1 and INT2. Internal interrupts are globally masked by IEF1 is 0.
Individual internal interrupts are enabled/disabled by programming each
UM005001-ZMP0400
ZILOG [ ZILOG, INC. ]
