R
Spartan and Spartan-XL FPGA Families Data Sheet
Spartan-XL Family IOB Output Switching Characteristic Guidelines
All devices are 100% functionally tested. Internal timing
parameters are derived from measuring internal test pat-
terns. Listed below are representative values. For more
specific, more precise, and worst-case guaranteed data,
use the values reported by the static timing analyzer (TRCE
in the Xilinx Development System) and back-annotated to
the simulation netlist. These path delays, provided as a
guideline, have been extracted from the static timing ana-
lyzer report. All timing parameters assume worst-case oper-
ating conditions (supply voltage and junction temperature).
Values are expressed in nanoseconds unless otherwise
noted.
Speed Grade
-5
-4
Symbol
Description
Device
Min
Max
Min
Max
Units
Propagation Delays
TOKPOF
TOPF
Clock (OK) to Pad, fast
Output (O) to Pad, fast
All devices
All devices
All devices
All devices
All devices
All devices
All devices
-
-
-
-
-
-
-
3.2
2.5
2.8
2.6
3.7
3.3
1.5
-
-
-
-
-
-
-
3.7
2.9
3.3
3.0
4.4
3.9
1.7
ns
ns
ns
ns
ns
ns
ns
TTSHZ
TTSONF
TOFPF
TOKFPF
TSLOW
3-state to Pad High-Z (slew-rate independent)
3-state to Pad active and valid, fast
Output (O) to Pad via Output Mux, fast
Select (OK) to Pad via Output Mux, fast
For Output SLOW option add
Setup and Hold Times
TOOK
TOKO
Output (O) to clock (OK) setup time
All devices
All devices
All devices
All devices
0.5
0.0
0.0
0.1
-
-
-
-
0.5
0.0
0.0
0.2
-
-
-
-
ns
ns
ns
ns
Output (O) to clock (OK) hold time
TECOK
TOKEC
Global Set/Reset
Clock Enable (EC) to clock (OK) setup time
Clock Enable (EC) to clock (OK) hold time
TMRW
TRPO
Minimum GSR pulse width
Delay from GSR input to any Pad
All devices
XCS05XL
XCS10XL
XCS20XL
XCS30XL
XCS40XL
10.5
-
11.5
-
ns
ns
ns
ns
ns
ns
-
-
-
-
-
11.9
12.4
12.9
13.9
14.9
-
-
-
-
-
14.0
14.5
15.0
16.0
17.0
Notes:
1. Output timing is measured at ~50% VCC threshold, with 50 pF external capacitive loads including test fixture. Slew-rate limited output
rise/fall times are approximately two times longer than fast output rise/fall times.
2. Voltage levels of unused pads, bonded or unbonded, must be valid logic levels. Each can be configured with the internal pull-up
(default) or pull-down resistor, or configured as a driven output, or can be driven from an external source.
DS060 (v1.8) June 26, 2008
www.xilinx.com
61
Product Specification
XILINX [ XILINX, INC ]
