W25M02GV
8.2.9 Read BBM Look Up Table (A5h)
The internal Look Up Table (LUT) consists of 20 Logical-Physical memory block links (from LBA0/PBA0 to
LBA19/PBA19). The “Read BBM Look Up Table” command can be used to check the existing address
links stored inside the LUT.
The “Read BBM Look Up Table” command is initiated by shifting the instruction code “A5h” into the DI pin
and followed by 8-bit dummy clocks, at the falling edge of the 16th clocks, the device will start to output the
16-bit “Logical Block Address” and the 16-bit “Physical Block Address” as illustrated in Figure 12. All block
address links will be output sequentially starting from the first link (LBA0 & PBA0) in the LUT. If there are
available links that are unused, the output will contain all “00h” data.
The MSB bits LBA[15:14] of each link are used to indicate the status of the link.
LBA[15]
(Enable)
LBA[14]
(Invalid)
Descriptions
This link is available to use.
0
1
1
0
0
0
1
1
This link is enabled and it is a valid link.
This link was enabled, but it is not valid any more.
Not applicable.
Figure 12. Read BBM Look Up Table Instruction
- 33 -
WINBOND [ WINBOND ]
