BCM3814x60E10A5yzz
3. The internal µC unsupported PMBus command code response as
described in the Fault Management and Reporting:
The internal µC Implementation vs.
PMBus™ Specification Rev 1.2
ꢀnꢀDeviations from the PMBus specification:
a. PMBus section 10.2.5.3, exceptions
The internal µC is an I2C compliant, SMBus™ compatible device
and PMBus command compliant device. This section denotes some
deviation, perceived as differences from the PMBus Part I and Part II
specification Rev 1.2.
• The busy bit of the STATUS_BYTE as implemented can
be cleared (80h). In order to maintain compatibility with
the specification (40h) can also be used.
1. The internal µC meets all Part I and II PMBus specification
requirements with the following differences to the
transport requirement.
nꢀManufacturer Implementation of the PMBus Spec
a. PMBus section 10.5, setting the response to a detected
fault condition
Unmet DC parameter Implementation vs SMBus™ spec
• All powertrain responses are pre-set and cannot be
changed. Refer to the BCM datasheet for details.
SMBus™
Rev 2.0
D44TL1A0
Symbol
Parameter
Units
Min Max Min Max
b. PMBus section 10.6, reporting faults and warnings
[a]
to the Host
VIL
Input Low Voltage
Input High Voltage
Input Leakage per Pin
-
0.99
-
-
0.8
V
V
[a]
• SMBALERT# signal and Direct PMBus Device to Host
Communication are not supported. However, the Digital
Supervisor will set the corresponding fault status bits and
will wait for the host to poll.
VIH
2.31
10
2.1 VVDD_IN
[b]
ILEAK_PIN
22
-
5
µA
[a]
V
= 3.3V
VDD_IN
[b]
c. PMBus section 10.7, clearing a shutdown due to a fault
V
= 5V
BUS
• There is no RESET pin or EN pin in the internal µC.
Cycling power to the internal µC will not clear a
BCM Shutdown. The BCM will clear itself once the fault
condition is removed. Refer to the BCM datasheet
for details.
2.The internal µC accepts 38 PMBus command codes.
Implemented commands execute functions as described in the
PMBus specification.
nꢀDeviations from the PMBus specification:
a. Section 15, fault related commands
d. PMBus Section 10.8.1, corrupted data transmission faults:
• Packet error checking is not supported.
• The limits and Warnings unit implemented is percentage
(%) a range from decimal (0-100) of the factory set limits.
Data Transmission Faults Implementation
This section describes data transmission faults as implemented in the internal µC.
Response to Host
STATUS_BYTE
STATUS_CML
Section
Description
Notes
Unsupported
NAK
FFh
CML
Other Fault
Data
10.8.1
10.8.2
10.8.3
Corrupted data
No response; PEC not supported
Sending too few bits
Reading too few bits
X
X
X
X
Host sends or reads too
few bytes
10.8.4
X
X
Host sends too many
bytes
10.8.5
10.8.6
X
X
X
X
X
Reading too many bytes
X
X
X
Device will ACK own address
BUSY bit in STATUS_BYTE even if
STATUS_WORD is set
10.8.7
Device busy
BCM® in a VIA Package
Page 34 of 39
Rev 1.4
09/2016
vicorpower.com
800 927.9474
VICOR [ VICOR CORPORATION ]
