TMS320F2809, TMS320F2808, TMS320F2806
TMS320F2802, TMS320F2801, UCD9501
TMS320C2802, TMS320C2801, and TMS320F2801x DSPs
www.ti.com
SPRS230H–OCTOBER 2003–REVISED JUNE 2006
eQEP:
The enhanced QEP peripheral uses a 32-bit position counter, supports low-speed
measurement using capture unit and high-speed measurement using a 32-bit unit timer.
This peripheral has a watchdog timer to detect motor stall and input error detection logic
to identify simultaneous edge transition in QEP signals.
ADC:
The ADC block is a 12-bit converter, single ended, 16-channels. It contains two
sample-and-hold units for simultaneous sampling.
3.2.21 Serial Port Peripherals
The 280x devices support the following serial communication peripherals:
eCAN:
This is the enhanced version of the CAN peripheral. It supports 32 mailboxes, time
stamping of messages, and is CAN 2.0B-compliant.
SPI:
The SPI is a high-speed, synchronous serial I/O port that allows a serial bit stream of
programmed length (one to sixteen bits) to be shifted into and out of the device at a
programmable bit-transfer rate. Normally, the SPI is used for communications between the
DSP controller and external peripherals or another processor. Typical applications include
external I/O or peripheral expansion through devices such as shift registers, display
drivers, and ADCs. Multi-device communications are supported by the master/slave
operation of the SPI. On the 280x, the SPI contains a 16-level receive and transmit FIFO
for reducing interrupt servicing overhead.
SCI:
I2C:
The serial communications interface is a two-wire asynchronous serial port, commonly
known as UART. On the 280x, the SCI contains a 16-level receive and transmit FIFO for
reducing interrupt servicing overhead.
The inter-integrated circuit (I2C) module provides an interface between a DSP and other
devices compliant with Philips Semiconductors Inter-IC bus (I2C-bus) specification version
2.1 and connected by way of an I2C-bus. External components attached to this 2-wire
serial bus can transmit/receive up to 8-bit data to/from the DSP through the I2C module.
On the 280x, the I2C contains a 16-level receive and transmit FIFO for reducing interrupt
servicing overhead.
3.3 Register Map
The 280x devices contain three peripheral register spaces. The spaces are categorized as follows:
Peripheral
Frame 0:
These are peripherals that are mapped directly to the CPU memory bus.
See Table 3-7
Peripheral
Frame 1
These are peripherals that are mapped to the 32-bit peripheral bus.
See Table 3-8
Peripheral
Frame 2:
These are peripherals that are mapped to the 16-bit peripheral bus.
See Table 3-9
Functional Overview
39
TI [ TEXAS INSTRUMENTS ]
