CATV Line Amplifiers/Power Inserters SIDACtor Device
CATV Line Amplifiers/Power Inserters
SIDACtor Device
This SIDACtor device is a 5000 A solid state protection device offered in a non-isolated
TO-218 package. It protects equipment located in the severe surge environment of CATV
(Community Antenna TV) applications.
1
2
In CATV line amplifiers and power inserters, this device can replace the gas tubes
traditionally used for station protection because SIDACtor devices have much tighter
voltage tolerances.
Electrical Parameters
Part
VDRM
VS
VT
IDRM
IS
IT
IH
CO
pF
Number *
Volts
Volts
Volts
µAmps
mAmps
Amps **
mAmps
P1900ME
P2300ME
140
180
220
260
4
4
5
5
800
800
2.2/25
2.2/25
50
50
750
750
* For surge ratings, see table below.
** IT is a free air rating; heat sink IT rating is 25 A.
General Notes:
•
•
•
•
•
•
•
All measurements are made at an ambient temperature of 25 °C. IPP applies to -40 °C through +85 °C temperature range.
I
PP is a repetitive surge rating and is guaranteed for the life of the product.
Listed SIDACtor devices are bi-directional. All electrical parameters and surge ratings apply to forward and reverse polarities.
V
DRM is measured at IDRM.
VS is measured at 100 V/µs.
Special voltage (VS and VDRM) and holding current (IH) requirements are available upon request.
Off-state capacitance is measured at 1 MHz with a 2 V bias and is a typical value.
Surge Ratings
IPP
ITSM
60 Hz
Amps
8x20 µs
di/dt
Series
Amps
Amps/µs
E
5000
400
500
http://www.teccor.com
+1 972-580-7777
2 - 64
© 2002 Teccor Electronics
®
SIDACtor Data Book and Design Guide
TECCOR [ TECCOR ELECTRONICS ]
