Electrical characteristics
STNRGPF01
5.3.5
I/O port pin characteristics
Subject to general operating conditions for V and T unless otherwise specified. Unused
DD
A
input pins should not be left floating.
Table 11. Voltage DC characteristics
Symbol
Description
Input low voltage
Input high voltage(2)
Output low voltage at 5 V(3) (4)
Min.(1)
Typ.
Max.(1) Unit
VIL
VIH
-0.3
0.7 x VDD
-
-
-
0.3 x VDD
VDD
VOL1
VOL3
,
-
0.5
Output low voltage high sink at 5 V(2) (5)
,
-
-
0.6
V
(4)
VOH1 Output high voltage at 5 V(3)
,
VDD - 0.5
VDD - 0.6
0.1 x VDD
30
-
-
-
VOH3 Output high voltage high sink at 5 V(2) (5)
,
-
HVS
RPU
Hysteresis input voltage(6)
-
-
Pull-up resistor
45
60
k
1. Data based on characterization result, not tested in production.
2. Input signals can't be exceeded VDDX (VDDX = VDD, VDDA).
3. The parameter applicable to signals on pins 14, 15, 20, 21, 22 and 23.
4. The parameter applicable to signals on pins 1, 4, 5, 8 16 and 19.
5. The parameter applicable to the signal on pin 2.
6. Applicable to pins 3, 6, 7, 17 and 18.
Table 12. Current DC characteristics
Symbol
Description
Min. Typ. Max.(1) Unit
(2) (3)
IOL1
Standard output low level current at 5 V and VOL1
,
-
-
-
-
-
-
-
-
-
-
-
-
-
-
3
(2) (4)
IOLhs1 High sink output low level current at 5 V and VOL3
,
7.75
3
mA
(2) (3)
IOH1
Standard output high level current at 5 V and VOH1
,
(2) (4)
IOHhs1 High sink output high level current at 5 V and VOH3
,
7.75
± 1
± 4
± 20
(5)
ILKg
I_Inj
Input leakage current digital - analog VSS ≤ VIN ≤ VDD
Injection current(6) (7)
µA
,
mA
I_Inj Total injection current sum of all I/O and control pins)(6)
1. Data based on characterization result, not tested in production.
2. The parameter applicable to signals on pins 14, 15, 20, 21, 22 and 23.
3. The parameter applicable to signals on pins1, 4, 5, 8 16 and 19.
4. The parameter applicable to the signal on pin 2.
5. Applicable to pins 3, 6, 7, 17 and 18.
6. Maximum value must never be exceeded.
7. Negative injection current on pins 31, 32, 33 and 34 must be avoided. It has impact on the measurement
section.
28/40
DocID030377 Rev 2
STMICROELECTRONICS [ ST ]
