Electrical characteristics
STNRGPF01
5.2
Absolute maximum ratings
Stresses above those listed as 'absolute maximum ratings' may cause permanent damage
to the device. This is a stress rating only and the functional operation of the device under
these conditions is not implied. Exposure to maximum rating conditions for extended
periods may affect the device reliability.
Table 4. Voltage characteristics
Symbol
Ratings
Min.
Max.
Unit
V
DDX - VSSX Supply voltage(1)
-0.3
6.5
V
VIN
Input voltage on any other pin(2)
VSS - 0.3 VDD + 0.3
VDD - VDDA Variation between different power pins
-
-
50
50
mV
VSS - VSSA Variation between all the different ground pins(3)
VESD
Electrostatic discharge voltage
Refer to Table 15 on page 33.
1. All power VDDX (VDD, VDDA) and ground VSSX (VSS, VSSA) pins must always be connected to the external
power supply.
2. IINJ(PIN) must never be exceeded. This is implicitly insured if VIN maximum is respected. If VIN maximum
cannot be respected, the injection current must be limited externally to the IINJ(PIN) value. A positive
injection is induced by VIN > VDD while a negative injection is induced by VIN < VSS
.
3. VSS and VSSA signals must be interconnected together with a short wire loop.
Table 5. Current characteristics
Symbol
Ratings
Max.(1)
Unit
IVDDX
IVSSX
Total current into VDDX power lines(2)
Total current out of VSSX power lines(2)
Output current sunk by any I/Os and control pin
Output current source by any I/Os and control pin
Injected current on any pin
100
100
Ref. to Table 12 on
IIO
mA
page 28
(3) (4)
IINJ(PIN)
,
± 4
(3) (4) (5)
IINJ(TOT)
,
,
Sum of injected currents
± 20
1. Data based on characterization results, not tested in production.
2. All power VDDX (VDD, VDDA) and ground VSSX (VSS, VSSA) pins must always be connected to the external
power supply.
3. IINJ(PIN) must never be exceeded. This is implicitly insured if VIN maximum is respected. If VIN maximum
cannot be respected, the injection current must be limited externally to the IINJ(PIN) value. A positive
injection is induced by VIN > VDD while a negative injection is induced by VIN < VSS
.
4. Negative injection disturbs the analog performance of the device.
5. When several inputs are submitted to a current injection, the maximum IINJ(PIN) is the absolute sum of the
positive and negative injected currents (instantaneous values). These results are based on
characterization with the IINJ(PIN) maximum current injection on four I/O port pins of the device.
Table 6. Thermal characteristics
Symbol
Ratings
Max.
Unit
TSTG
TJ
Storage temperature range
-65 to 150
150
ºC
Maximum junction temperature
24/40
DocID030377 Rev 2