STM8S003F3 STM8S003K3
Electrical characteristics
9.1.6
Pin input voltage
The input voltage measurement on a pin of the device is described in Figure 8.
Figure 8. Pin input voltage
STM8 pin
V
IN
9.2
Absolute maximum ratings
Stresses above those listed as ‘absolute maximum ratings’ may cause permanent damage
to the device. This is a stress rating only and functional operation of the device under these
conditions is not implied. Exposure to maximum rating conditions for extended periods may
affect device reliability.
Table 16. Voltage characteristics
Symbol
Ratings
Min
Max
Unit
(1)
V
DDx - VSS Supply voltage (including VDDA and VDDIO
)
-0.3
6.5
6.5
Input voltage on true open drain pins (PE1, PE2)(2)
Input voltage on any other pin(2)
VSS - 0.3
V
VIN
VSS - 0.3 VDD + 0.3
|VDDx - VDD| Variations between different power pins
-
-
50
50
mV
-
|VSSx - VSS| Variations between all the different ground pins
see Absolute maximum
ratings (electrical
VESD
Electrostatic discharge voltage
sensitivity) on page 86
1. All power (VDD, VDDIO, VDDA) and ground (VSS, VSSIO, VSSA) pins must always be connected to the
external power supply
2. IINJ(PIN) must never be exceeded. This is implicitly insured if VIN maximum is respected. If VIN maximum
cannot be respected, the injection current must be limited externally to the IINJ(PIN) value. A positive
injection is induced by VIN>VDD while a negative injection is induced by VIN<VSS. For true open-drain pads,
there is no positive injection current, and the corresponding VIN maximum must always be respected
DocID018576 Rev 5
47/103
87
STMICROELECTRONICS [ ST ]
