Highly Efficient Single-Chip 10/100 Ethernet Controller with HP Auto-MDIX and Industrial Temperature Support
Datasheet
6.4
RX Data FIFO Direct PIO Reads
In this mode the upper address inputs are not decoded, and any read of the LAN9215I will read the
RX Data FIFO. This mode is enabled when FIFO_SEL is driven high during a read access. This is
normally accomplished by connecting the FIFO_SEL signal to high-order address line. This mode is
useful when the host processor must increment its address when accessing the LAN9215I . Timing is
identical to a PIO read, and the FIFO_SEL signal has the same timing characteristics as the address
lines.
Note that address lines A[2:1] are still used, and address bits A[7:3] are ignored.
FIFO_SEL
A[2:1]
nCS, nRD
Data Bus
Figure 6.3 RX Data FIFO Direct PIO Read Cycle Timing
Note: The “Data Bus” width is 16 bits
Table 6.5 RX Data FIFO Direct PIO Read Timing
MIN
SYMBOL
DESCRIPTION
TYP
MAX
UNITS
tcycle
tcsl
Read Cycle Time
165
32
ns
ns
ns
ns
ns
ns
ns
ns
ns
nCS, nRD Assertion Time
tcsh
tcsdv
tasu
tah
nCS, nRD Deassertion Time (see Note below)
nCS, nRD Valid to Data Valid
Address, FIFO_SEL Setup to nCS, nRD Valid
Address, FIFO_SEL Hold Time
Data Buffer Turn On Time
13
133
30
0
0
0
tdon
tdoff
tdoh
Data Buffer Turn Off Time
7
Data Output Hold Time
0
Note: An RX Data FIFO Direct PIO Read cycle begins when both nCS and nRD are asserted. The
cycle ends when either or both nCS and nRD are de-asserted. They may be asserted and de-
asserted in any order. Parameters tcsh and tcsl must be extended using wait states to meet the
tcycle minimum.
SMSC LAN9215I
123
Revision 1.5 (07-18-06)
DATASHEET