欢迎访问ic37.com |
会员登录 免费注册
发布采购

LAN91C96-MU 参数 Datasheet PDF下载

LAN91C96-MU图片预览
型号: LAN91C96-MU
PDF下载: 下载PDF文件 查看货源
内容描述: 非PCI单芯片全双工以太网控制器魔包 [Non-PCI Single-Chip Full Duplex Ethernet Controller with Magic Packet]
分类和应用: 控制器PC以太网
文件页数/大小: 125 页 / 776 K
品牌: SMSC [ SMSC CORPORATION ]
 浏览型号LAN91C96-MU的Datasheet PDF文件第42页浏览型号LAN91C96-MU的Datasheet PDF文件第43页浏览型号LAN91C96-MU的Datasheet PDF文件第44页浏览型号LAN91C96-MU的Datasheet PDF文件第45页浏览型号LAN91C96-MU的Datasheet PDF文件第47页浏览型号LAN91C96-MU的Datasheet PDF文件第48页浏览型号LAN91C96-MU的Datasheet PDF文件第49页浏览型号LAN91C96-MU的Datasheet PDF文件第50页  
Non-PCI Single-Chip Full Duplex Ethernet Controller with Magic Packet  
I/O SPACE - BANK0  
OFFSET  
4
NAME  
TYPE  
READ/WRITE  
SYMBOL  
RCR  
RECEIVE CONTROL REGISTER  
SOFT  
RST  
0
FILT  
CAR  
0
0
0
0
0
0
0
0
STRIP  
CRC  
0
RXEN  
0
0
RX_  
ABORT  
0
ALMUL  
PRMS  
0
0
0
0
0
0
0
SOFT_RST - Software activated Reset. Active high. Initiated by writing this bit high and terminated by  
writing the bit low. The LAN91C96 configuration is not preserved, except for Configuration, Base, and IA0-  
5 Registers. The EEPROM in both LOCAL BUS and PCMCIA mode is not reloaded after software reset.  
FILT_CAR - Filter Carrier. When set filters leading edge of carrier sense for 12 bit times. Otherwise  
recognizes a receive frame as soon as carrier sense is active.  
STRIP_CRC - When set it strips the CRC on received frames. When clear the CRC is stored in memory  
following the packet. Defaults low.  
RXEN - Enables the receiver when set. If cleared, completes receiving current frame and then goes idle.  
Defaults low on reset.  
ALMUL - When set accepts all multicast frames (frames in which the first bit of DA is '1'). When clear  
accepts only the multicast frames that match the multicast table setting. Defaults low.  
PRMS - Promiscuous mode. When set receives all frames.  
Change vs. LAN91C92: Does not receive its own transmission when not in full duplex(FDUPLX)!.  
RX_ABORT - This bit is set if a receive frame was aborted due to length longer than 1532 bytes. The  
frame will not be received. The bit is cleared by RESET or by the CPU writing it low.  
I/O SPACE - BANK0  
OFFSET  
6
NAME  
COUNTER REGISTER  
TYPE  
READ ONLY  
SYMBOL  
ECR  
Counts four parameters for MAC statistics. When any counter reaches 15 an interrupt is issued. All  
counters are cleared when reading the register, and do not wrap around beyond 15.  
NUMBER OF EXC. DEFERRED TX  
NUMBER OF DEFERRED TX  
0
0
0
0
0
0
0
0
0
0
0
0
MULTIPLE COLLISION COUNT  
SINGLE COLLISION COUNT  
0
0
0
0
Each four bit counter is incremented every time the corresponding event, as defined in the EPH STATUS  
REGISTER bit description, occurs. Note that the counters can only increment once per enqueued transmit  
packet, never faster, limiting the rate of interrupts that can be generated by the counters. For example if a  
packet is successfully transmitted after one collision the SINGLE COLLISION COUNT field is incremented  
by one. If a packet experiences between 2 to 16 collisions, the MULTIPLE COLLISION COUNT field is  
incremented by one.  
If a packet experiences deferral the NUMBER OF DEFERRED TX field is incremented by one, even if the  
packet experienced multiple deferrals during its collision retries.  
Rev. 09/10/2004  
Page 46  
SMSC LAN91C965v&3v  
DATASHEET  
 复制成功!