RPM-Based Fan Controller with Multiple Temperature Zones & Hardware Thermal Shutdown
Datasheet
7.10
Critical Temperature Limit Registers
Table 7.15 Limit Registers
ADDR
R/W
REGISTER
B7
B6
B5
B4
B3
B2
B1
B0
DEFAULT
R/W
once
External Diode
1 Tcrit Limit
64h
(+100°C)
19h
1Ah
1Bh
1Dh
Sign
64
32
16
8
4
2
1
R/W
once
External Diode
2 Tcrit Limit
64h
(+100°C)
Sign
Sign
Sign
64
64
64
32
32
32
16
16
16
8
8
8
4
4
4
2
2
2
1
1
1
R/W
once
External Diode
3 Tcrit Limit
64h
(+100°C)
R/W
once
Internal Diode
Tcrit Limit
64h
(+100°C)
The Critical Temperature Limit Registers store the Critical Temperature Limit. At power up, none of the
respective channels are linked to the SYS_SHDN pin or the Hardware set Thermal/Critical Shutdown
circuitry.
Whenever one of the registers is updated, two things occur. First, the register is locked so that it cannot
be updated again without a power on reset. Second, the respective temperature channel is linked to
the SYS_SHDN pin and the Hardware set Thermal/Critical Shutdown Circuitry. At this point, if the
measured temperature channel meets or exceeds the critical limit, the SYS_SHDN pin will be asserted,
the appropriate bit set in the Tcrit Status Register, and the TCRIT bit in the Interrupt Status Register
will be set.
7.11
Configuration Register
Table 7.16 Configuration Register
ADDR
R/W
R/W
REGISTER
B7
B6
B5
B4
B3
B2
B1
B0
DEFAULT
20h
Configuration MASK
WD_EN
-
-
SYS3
SYS2
SYS1
APD
00h
The Configuration Register controls the basic functionality of the EMC2113. The bits are described
below.
Bit 7 - MASK - Blocks the ALERT pin from being asserted.
‘0’ (default) - The ALERT pin is unmasked. If any bit in either status register is set, the ALERT pin
will be asserted (unless individually masked via the Mask Register)
‘1’ - The ALERT pin is masked and will not be asserted.
Bit 6 - WD_EN - Enables the Watchdog timer to operate in Continuous Mode.
‘0’ (default) - The Watchdog timer does not operate continuously. It will function upon power up and
at no other time.
‘1’ - The Watchdog timer operates continuously as described in Section 6.10.2, "Continuous
Operation".
Bit 3 - SYS3 - Enables the high temperature limit for the External Diode 3 channel to trigger the
Critical/Thermal Shutdown circuitry (see Section 6.1, "Critical/Thermal Shutdown").
‘0’ (default) - the External Diode 3 channel high limit will not be linked to the SYS_SHDN pin. If the
temperature meets or exceeds the limit, the ALERT pin will be asserted normally.
Revision 1.2 (10-08-09)
SMSC EMC2113
DATA5S0HEET
SMSC [ SMSC CORPORATION ]
