ST7565S
Static Indicator Register Set
This command sets two bits of data into the static indicator register, and is used to set the static indicator into a blinking mode.
E
R/W
A0 /RD /WR
D7 D6 D5 D4 D3 D2 D1 D0
Indicator Display State
*
*
*
*
*
*
0
0
1
1
0
1
0
OFF
ON (blinking at approximately one second intervals)
ON (blinking at approximately 0.5 second intervals)
ON (constantly on)
0
1
0
1
* Disabled bit (set “0”)
Static Indicator Register Set Sequence
Static indicator mode set
Static indicator register set
Static indicator mode clear
NO
Set complete ?
YES
Figure 27
Power Save (Compound Command)
When the display all points ON is performed while the display is in the OFF mode, the power saver mode is entered, thus greatly
reducing power consumption.
The power saver mode has two different modes: the sleep mode and the standby mode. When the static indicator is OFF, it is
the sleep mode that is entered. When the static indicator is ON, it is the standby mode that is entered.
In the sleep mode and in the standby mode, the display data is saved as is the operating mode that was in effect before the
power saver mode was initiated, and the MPU is still able to access the display data RAM.
Refer to figure 28 for power save off sequence.
Static indicator ON
Static indicator OFF
Display OFF
Display OFF
Display all point ON
Display all point ON
Standby mode
Sleep mode
Power save OFF
Power save OFF
( Display all point OFF )
Display all point OFF
Static indicator ON (2 bytes)
Standby mode cancel
Sleep mode cancel
Figure 28
Ver 0.6c
49/72
2009/09/07
SITRONIX [ SITRONIX TECHNOLOGY CO., LTD. ]
