LC72121, 72121M, 72121V
IF Counter Operation
Applications must first, before starting an IF count operation reset the IF counter by setting CTE in the serial data to 0.
The IF counter operation is started setting CTE in the serial data from 0 to 1. Although the serial data is latched by
dropping the CE pin from high to low, the IF signal input to the IFIN pin must be provided within the wait time from the
point CE goes low. Next, the readout of the IF counter after measurement is complete must be performed while CTE is
still 1, since the counter will be reset if CTE is set to 0.
Note: If IF counting is used, applications must determine whether or not the IF IC SD (station detect) signal is present in
the microcontroller software, and perform the IF count only if that signal is asserted. This is because auto-search
techniques that use IF counting only are subject to incorrect stopping at points where there is no station due to IF
buffer leakage.
Note that the LC72121 input sensitivity can be controlled with the IFS bit in the serial data.
Reduced sensitivity mode (IFS = 0) must be selected when this IC is used in conjunction with an IF IC that does
not provide an SD output and auto-search is implemented using only IF counting.
IFIN Minimum Sensitivity Standard
Input frequency : f [MHz]
IFS data
0.4 ≤ f < 0.5
0.5 ≤ f < 0.8
40 mVrms
70 mVrms
8 ≤ f ≤ 12
1(Normal mode)
40 mVrms (0.1 to 3 mVrms)
70 mVrms (10 to 15 mVrms)
40 mVrms (1 to 10 mVrms)
70 Vrms (30 to 40 mVrms)
0 (Degraded sensitivity mode)
Note: Values in parentheses are actual performance values that are provided for reference purposes.
No. 5815-16/22
SANYO [ SANYO SEMICON DEVICE ]
