欢迎访问ic37.com |
会员登录 免费注册
发布采购

HD64F3337YF16 参数 Datasheet PDF下载

HD64F3337YF16图片预览
型号: HD64F3337YF16
PDF下载: 下载PDF文件 查看货源
内容描述: 单片机 [Single-Chip Microcomputer]
分类和应用: 微控制器和处理器外围集成电路
文件页数/大小: 747 页 / 2993 K
品牌: RENESAS [ RENESAS TECHNOLOGY CORP ]
 浏览型号HD64F3337YF16的Datasheet PDF文件第436页浏览型号HD64F3337YF16的Datasheet PDF文件第437页浏览型号HD64F3337YF16的Datasheet PDF文件第438页浏览型号HD64F3337YF16的Datasheet PDF文件第439页浏览型号HD64F3337YF16的Datasheet PDF文件第441页浏览型号HD64F3337YF16的Datasheet PDF文件第442页浏览型号HD64F3337YF16的Datasheet PDF文件第443页浏览型号HD64F3337YF16的Datasheet PDF文件第444页  
19.4.7  
Prewrite Verify Mode  
Prewrite-verify mode is a verify mode used when programming all bits to equalize their threshold  
voltages before erasing them.  
Program all flash memory to H'00 by writing H'00 using the prewrite algorithm shown in figure  
19.10. H'00 should also be written when using RAM for flash memory emulation (when  
prewriting a RAM area). (This also applies when using RAM to emulate flash memory erasing  
with an emulator or other support tool.) After the necessary programming time has elapsed, exit  
program mode (by clearing the P bit to 0) and select prewrite-verify mode (leave the P, E, PV, and  
EV bits all cleared to 0). In prewrite-verify mode, a prewrite-verify voltage is applied to the  
memory cells at the read address. If the flash memory is read in this state, the data at the read  
address will be read. After selecting prewrite-verify mode, wait 4 µs or more before reading.  
Note: For a sample prewriting program, see the prewrite subroutine in the sample erasing  
program.  
19.4.8  
Protect Modes  
Flash memory can be protected from programming and erasing by software or hardware methods.  
These two protection modes are described below.  
Software Protection: Prevents transitions to program mode and erase mode even if the P or E bit  
is set in the flash memory control register (FLMCR). Details are as follows.  
Function  
Protection Description  
Program Erase  
Verify*1  
Block  
Individual blocks can be protected from erasing Disabled  
Disabled Enabled  
protect  
and programming by the erase block registers  
(EBR1 and EBR2). If H'F0 is set in EBR1 and  
H'00 in EBR2, all blocks are protected from  
erasing and programming.  
Emulation  
protect*2  
When the RAMS or RAM0 bit, but not both,  
is set in the wait-state control register (WSCR),  
all blocks are protected from programming and  
erasing.  
Disabled  
Disabled*3 Enabled  
Notes: *1 Three modes: program-verify, erase-verify, and prewrite-verify.  
*2 Except in RAM areas overlapped onto flash memory.  
*3 All blocks are erase-disabled. It is not possible to specify individual blocks.  
410  
 复制成功!