Section 22 Electrical Characteristics
22.3.9
Power-On Reset Circuit Characteristics
Table 22.21 Power-On Reset Circuit Characteristics
VSS = 0.0 V, Ta = -20 to +75°C/-40 to +85°C, unless otherwise indicated.
Values
Test
Item
Symbol
RRES
Condition
Min.
100
—
Typ.
150
—
Max
—
Unit
kΩ
Pull-up resistance of RES pin
Power-on reset start voltage*
Vpor
100
mV
Note:
*
The power-supply voltage (Vcc) must fall below Vpor = 100 mV and then rise after
charge of the RES pin is removed completely. In order to remove charge of the RES
pin, it is recommended that the diode be placed in the Vcc side. If the power-supply
voltage (Vcc) rises from the point over 100 mV, a power-on reset may not occur.
Rev. 3.00 Sep. 10, 2007 Page 454 of 528
REJ09B0216-0300
RENESAS [ RENESAS TECHNOLOGY CORP ]
