•
•
EMODE: Double-sized cache mode bit
In the SH7750R, this bit indicates whether the double-sized cache mode is used or not.
This bit is reserved in the SH7750 and SH7750S. The EMODE bit must not be written to while
the cache is being used.
0: SH7750/SH7750S-compatible mode*1 (initial value)
1: Double-sized cache mode
IIX: IC index enable bit
0: Effective address bits [12:5] used for IC entry selection
1: Effective address bits [25] and [11:5] used for IC entry selection
•
•
ICI: IC invalidation bit
When 1 is written to this bit, the V bits of all IC entries are cleared to 0. This bit always returns
0 when read.
ICE: IC enable bit
Indicates whether or not the IC is to be used. When address translation is performed, the IC
cannot be used unless the C bit in the page management information is also 1.
0: IC not used
1: IC used
•
•
OIX: OC index enable bit*2
0: Effective address bits [13:5] used for OC entry selection
1: Effective address bits [25] and [12:5] used for OC entry selection
ORA: OC RAM enable bit*3
When the OC is enabled (OCE = 1), the ORA bit specifies whether the half of the OC are to be
used as RAM. When the OC is not enabled (OCE = 0), the ORA bit should be cleared to 0.
0: Normal mode (the entire OC is used as a cache)
1: RAM mode (half of the OC is used as a cache and the other half is used as RAM)
•
•
OCI: OC invalidation bit
When 1 is written to this bit, the V and U bits of all OC entries are cleared to 0. This bit always
returns 0 when read.
CB: Copy-back bit
Indicates the P1 area cache write mode.
0: Write-through mode
1: Copy-back mode
Rev. 6.0, 07/02, page 98 of 986
RENESAS [ RENESAS TECHNOLOGY CORP ]
