TG-201902141228EP
voltage distribution, heat dissipation and others.
3.The technical information shown in the data sheets are limited to the typical characteristics and circuit
examples of the referenced products. It does not constitute the warranting of industrial property nor the granting
of any license.
3. Soldering Instructions
300 °C
3
350 °C
5
(1) The hand solder should be done only one time
(2) When soldering , do not put stress on the COBs’silicone
(3) When soldering , put COB on the Surface of a poor conductor of heat
(4) Don’t remove the protective film on the silicone until soldering end
Soldering Iron
(1) When hand soldering, keep the temperature of iron below less 350℃ less than 5 seconds.
The tip of the iron tip is the blade
Repairing
Repair should not be done after the COBs have been soldered. When repairing is unavoidable,a
double-head soldering iron should be used (as below figure). It should be confirmed in advance
whether the characteristics of COBs will or will not be damaged by repairing. When COBs are
repairing ,don’t use soldering iron scrape pad of COBs.
Tel: +86-755-66839118 Fax:+86-755-66839300 E-mail:sales@refond.com Web: www.refond.com
REFOND:WI-E-045 A/3 REV:E/0
PAGE:18
REFOND [ SHENZHEN REFOND OPTOELECTRONICS CO.,LTD. ]
