HYB25D256[400/800/160]B[T/C](L)
256-Mbit Double Data Rate SDRAM
Functional Description
3.2.4
Operating Mode
The normal operating mode is selected by issuing a Mode Register Set Command with bits A7-A12 set to zero,
and bits A0-A6 set to the desired values. A DLL reset is initiated by issuing a Mode Register Set command with
bits A7 and A9-A12 each set to zero, bit A8 set to one, and bits A0-A6 set to the desired values. A Mode Register
Set command issued to reset the DLL should always be followed by a Mode Register Set command to select
normal operating mode.
All other combinations of values for A7-A12 are reserved for future use and/or test modes. Test modes and
reserved states should not be used as unknown operation or incompatibility with future versions may result.
CAS Latency = 2, BL = 4
CK
CK
Read
NOP
NOP
NOP
NOP
NOP
Command
CL=2
DQS
DQ
CAS Latency = 2.5, BL = 4
CK
CK
Read
NOP
NOP
NOP
NOP
NOP
Command
CL=2.5
DQS
DQ
Shown with nominal tAC, tDQSCK, and tDQSQ
.
Don’t Care
Figure 6
Required CAS Latencies
Data Sheet
19
Rev. 1.21, 2004-07
02102004-TSR1-4ZWW