Internet Data Sheet
HYB18H512321BF
512-Mbit GDDR3
3
Functional Description
3.1
Mode Register Set Command (MRS)
The Mode Register stores the data for controlling the
operation modes of the memory. It programs CAS latency,
test mode, DLL Reset , the value of the Write Latency and the
Burst length. The Mode Register must be written after power
up to operate the SGRAM. During a ModeRegister Set
command the address inputs are sampled and stored in the
Mode Register. The Mode Register content can only be set or
changed when the chip is in Idle state. For non-READ
commands following a Mode Register Set a delay of tMRD
must be met.
FIGURE 2
Mode Register Set Command
CLK#
CLK
CKE
CS#
The Mode Register Bitmap is supported in two configurations.
The first configuration is intended to support the Mid-Range-
Speed application. The second configuration supports higher
clock cycles for CAS latency and is therefore prepared to
support high-speed application. The selected configuration is
defined by Bit0 of EMRS2.
RAS#
CAS#
WE#
A0-A11
BA0
COD
0
0
COD: Code to be loaded into
the register
BA1, BA2
Don't Care
Rev. 1.3, 2007-12
05292007-WAU2-UU95
11
QIMONDA [ QIMONDA AG ]
