CAT1021, CAT1022, CAT1023
Page Write
The CAT1021/22/23 writes up to 16 bytes of data in a
single write cycle, using the Page Write operation. The page
write operation is initiated in the same manner as the byte
write operation, however instead of terminating after the
initial byte is transmitted, the Master is allowed to send up
to 15 additional bytes. After each byte has been transmitted,
the CAT1021/22/23 will respond with an acknowledge and
internally increment the lower order address bits by one. The
high order bits remain unchanged.
If the Master transmits more than 16 bytes before sending
the STOP condition, the address counter ‘wraps around,’
and previously transmitted data will be overwritten.
When all 16 bytes are received, and the STOP condition
has been sent by the Master, the internal programming cycle
begins. At this point, all received data is written to the
CAT1021/22/23 in a single write cycle.
S
T
A
R
T
S
T
O
P
BUS ACTIVITY:
MASTER
SLAVE
ADDRESS
BYTE
ADDRESS
DATA
SDA LINE
S
P
A
C
K
A
C
K
A
C
K
Figure 8. Byte Write Timing
S
T
A
S
T
O
P
BUS ACTIVITY:
MASTER
SLAVE
ADDRESS
BYTE
ADDRESS (n)
R
DATAꢁn
DATA nꢀ+ꢀ1
DATA n+15
T
S
SDA LINE
P
A
C
K
A
C
K
A
C
K
A
C
K
A
C
K
Figure 9. Page Write Timing
Acknowledge Polling
Disabling of the inputs can be used to take advantage of
the typical write cycle time. Once the stop condition is issued
to indicate the end of the host’s write opration, the
CAT1021/22/23 initiates the internal write cycle. ACK
polling can be initiated immediately. This involves issuing
the start condition followed by the slave address for a write
operation. If the device is still busy with the write operation,
no ACK will be returned. If a write operation has completed,
an ACK will be returned and the host can then proceed with
the next read or write operation.
WRITE PROTECTION PIN (WP)
The Write Protection feature (CAT1021 only) allows the
user to protect against inadvertent memory array
programming. If the WP pin is tied to VCC, the entire
memory array is protected and becomes read only. The
CAT1021 will accept both slave and byte addresses, but the
memory location accessed is protected from programming
by the device’s failure to send an acknowledge after the first
byte of data is received.
READ OPERATIONS
The READ operation for the CAT1021/22/23 is initiated
in the same manner as the write operation with one
exception, the R/W bit is set to one. Three different READ
operations are possible: Immediate/Current Address
READ, Selective/Random READ and Sequential READ.
http://onsemi.com
11
ONSEMI [ ONSEMI ]
