TDA6650TT; TDA6651TT
NXP Semiconductors
5 V mixer/oscillator and low noise PLL synthesizer
Table 22. Characteristics…continued
VCCA = VCCD = 5 V; Tamb = 25 °C; values are given for an asymmetrical IF output loaded with a 75 Ω load or with a
symmetrical IF output loaded with 1.25 kΩ; positive currents are entering the IC and negative currents are going out of the IC;
the performances of the circuits are measured in the measurement circuits Figure 27 and 28 for digital application or in the
measurement circuits Figure 29 and 30 for hybrid application; unless otherwise specified.
Symbol
Parameter
Conditions
CC = 5 V ± 5 %; worst case in the frequency
range; ripple frequency 500 kHz
Min
Typ Max
140
Unit
[12]
RSCp-p
ripple susceptibility of
V
15
-
mV
VCC (peak-to-peak
value)
High band oscillator
[9]
fosc
oscillator frequency
482.15 -
902.15 MHz
[10]
∆fosc(V)
oscillator frequency shift
with supply voltage
-
300
-
kHz
[11]
∆fosc(T)
oscillator frequency drift ∆T = 25 °C; VCC = 5 V; with compensation
-
1100 -
kHz
with temperature
Φosc(dig)
phase noise, carrier to
TDA6650TT/C3/S2; TDA6651TT/C3/S2;
sideband noise in digital TDA6651TT/C3/S3
application
±1 kHz frequency offset; fcomp = 4 MHz;
85
87
89
93
-
-
dBc/Hz
dBc/Hz
see Figure 8, 27 and 28
±10 kHz frequency offset; worst case in
the frequency range;
see Figure 9, 27 and 28
±100 kHz frequency offset; worst case in
the frequency range;
see Figure 10, 27 and 28
104
-
107
117
-
-
dBc/Hz
dBc/Hz
±1.4 MHz frequency offset; worst case in
the frequency range; see Figure 27 and 28
Φosc(hyb)
phase noise, carrier to
sideband noise in hybrid
application
TDA6650TT/C3; TDA6651TT/C3
±1 kHz frequency offset; fcomp = 4 MHz;
see Figure 11, 29, and 30
80
82
85
86
-
-
dBc/Hz
dBc/Hz
±10 kHz frequency offset; worst case in
the frequency range;
see Figure 12, 29, and 30
±100 kHz frequency offset; worst case in
the frequency range;
104
107
-
dBc/Hz
see Figure 13, 29, and 30
±1.4 MHz frequency offset; worst case in
the frequency range; see Figure 29 and 30
-
117
40
-
-
dBc/Hz
mV
[12]
RSCp-p
ripple susceptibility of
VCC = 5 V ± 5 %; worst case in the frequency
15
VCC (peak-to-peak
range; ripple frequency 500 kHz
value)
IF amplifier
Zo
output impedance
asymmetrical IF output
RS at 38.9 MHz
-
-
-
-
-
50
-
-
-
-
-
Ω
LS at 38.9 MHz
5.4
nH
symmetrical IF output
RS at 38.9 MHz
100
Ω
LS at 38.9 MHz
10.4
nH
Rejection at the IF output (IF amplifier in asymmetrical mode)
TDA6650TT_6651TT_5
© NXP B.V. 2007. All rights reserved.
Product data sheet
Rev. 05 — 10 January 2007
27 of 54