■AEC-Q200 Murata Standard Specification and Test Methods
No
7
AEC-Q200 Test Item
Specification.
AEC-Q200 Test Method
The measured and observed characteristics should satisfy the
specifications in the following table.
Operational Life
Solder the capacitor on the test substrate(glass epoxy board).
Apply 200% of the rated voltage for 1000+/-12h at 125+/-3℃.
The charge/discharge current is less than 50mA.
Appearance No marking defects
Set for 24+/-2h at room temperature, then measure.
Capacitance Within +/-12.5%
Change
・Initial measurement
Apply the test voltage at the max. operating temp. +/-3°C for 1h
and then let sit for 24+/-2h at room temperature,then measure.
D.F.
0.035 max.
I.R.
More than 1,000MΩ or 50Ω・F
25℃
(Whichever is smaller)
8
9
External Visual
No defects or abnormalities
Visual inspection
Physical Dimension
Within the specified dimensions
Using Measuring instrument of dimension.
10 Resistance to Appearance No marking defects
Solvents
Per MIL-STD-202 Method 215
Solvent 1 : 1 part (by volume) of isopropyl alcohol
3 parts (by volume) of mineral spirits
Capacitance Within the specified initial value.
Solvent 2 : Terpene defluxer
D.F.
Within the specified initial value.
Within the specified initial value.
Solvent 3 : 42 parts (by volume) of water
1 part (by volume) of propylene glycol monomethyl ether
1 part (by volume) of monoethanolamine
I.R.
25℃
11 Mechanical
Shock
Appearance No marking defects
Solder the capacitor on the test substrate(glass epoxy board).
Three shocks in each direction should be applied along 3 mutually
perpendicular axes of the test specimen (18 shocks).
Capacitance Within the specified initial value.
The specified test pulse should be Half-sine and should have a
duration :0.5ms, peak value:1500g and velocity change: 4.7m/s.
D.F.
Within the specified initial value.
Within the specified initial value.
I.R.
25℃
12 Vibration
Appearance No defects or abnormalities
Solder the capacitor on the test substrate(glass epoxy board).
The capacitor should be subjected to a simple harmonic motion having
a total amplitude of 1.5mm, the frequency being varied uniformly
between the approximate limits of 10 and 2000Hz.
Capacitance Within the specified initial value.
D.F.
Within the specified initial value.
Within the specified initial value.
The frequency range, from 10 to 2000Hz and return to 10Hz,
should be traversed in approximately 20 minutes.
I.R.
This motion should be applied for 12 items in each 3 mutually
25℃
perpendicular directions (total of 36 times).
The measured and observed characteristics should satisfy the
specifications in the following table.
13 Resistance to
Soldering Heat
Immerse the capacitor in Sn-3.0Ag-0.5Cu solder solution or an eutectic
solder solution at 260+/-5℃ for 10+/-1s.
Appearance No marking defects
Set at room temperature for 24+/-2h, then measure.
Capacitance Within the specified initial value.
・Initial measurement
Perform a heat treatment at 150+0/-10 ℃ for 1h and then set
for 24+/-2h at room temperature.
D.F.
Within the specified initial value.
Within the specified initial value.
Perform the initial measurement.
I.R.
25℃
JEMCGS-00806D
3
MURATA [ muRata ]
