PB7
PB6
PB5
PB4
PB3
PB2
PB1
PB0
A15
A14
A13
A12
A11
A10
A9
A8
MC54/74HC373
MC68HC11A8
PC7
PC6
PC5
PC4
PC3
PC2
PC1
PC0
D1
D2
D3
D4
D5
D6
D7
D8
Q1
A7
A6
A5
A4
A3
A2
A1
A0
Q2
Q3
Q4
Q5
Q6
Q7
Q8
AS
LE
OE
R/W
E
WE
D7
D6
D5
D4
D3
D2
D1
D0
Figure 4 Address/Data Demultiplexing
Special bootstrap mode allows special purpose programs to be entered into internal RAM. The boot-
loader program uses the SCI to read a 256-byte program into on-chip RAM at $0000 through $00FF.
After receiving the character for address $00FF, control passes to the loaded program at $0000.
Special test mode is used primarily for factory testing.
2.1 Memory Maps
Memory locations are the same for expanded multiplexed and single-chip modes. The on-board 256-
byte RAM is initially located at $0000 after reset. The 64-byte register block originates at $1000 after
reset. RAM and/or the register block can be placed at any other 4K boundary ($x000) after reset by writ-
ing an appropriate value to the INIT register. The 512-byte EEPROM is located at $B600 through $B7FF
after reset if it is enabled. The 8 Kbyte ROM is located at $E000 through $FFFF if it is enabled.
Hardware priority is built into the memory remapping. Registers have priority over RAM, and RAM has
priority over ROM. The higher priority resource covers the lower, making the underlying locations inac-
cessible.
In special bootstrap mode, a bootloader ROM is enabled at locations $BF40 through $BFFF.
In special test and special bootstrap modes, reset and interrupt vectors are located at $BFC0 through
$BFFF.
MC68HC11A8
MC68HC11A8TS/D
MOTOROLA
7
MOTOROLA [ MOTOROLA ]
