P30-65nm
Figure 14: Reset Operation Waveforms
P1
P2
P2
P3
R5
VIH
VIL
(
A) Reset during
read mode
RST# [P]
RST# [P]
RST# [P]
VCC
Abort
Complete
R5
(B) Reset during
VIH
VIL
program or block erase
P1
≤ P2
Abort
Complete
R5
(C) Reset during
VIH
VIL
program or block erase
P1
≥ P2
VCC
0V
(D) VCC Power-up to
RST# high
12.3
Power Supply Decoupling
Flash memory devices require careful power supply de-coupling. Three basic power
supply current considerations are: 1) standby current levels; 2) active current levels;
and 3) transient peaks produced when CE# and OE# are asserted and deasserted.
When the device is accessed, many internal conditions change. Circuits within the
device enable charge-pumps, and internal logic states change at high speed. All of
these internal activities produce transient signals. Transient current magnitudes depend
on the device outputs’ capacitive and inductive loading. Two-line control and correct
de-coupling capacitor selection suppress transient voltage peaks.
Because flash memory devices draw their power from VCC, VPP, and VCCQ, each power
connection should have a 0.1 µF ceramic capacitor to ground. High-frequency,
inherently low-inductance capacitors should be placed as close as possible to package
leads.
Additionally, for every eight devices used in the system, a 4.7 µF electrolytic capacitor
should be placed between power and ground close to the devices. The bulk capacitor is
meant to overcome voltage droop caused by PCB trace inductance.
Datasheet
45
Sept 2012
OrderNumber:208042-06